Irinox Fresco D2000110 - Инструкция по эксплуатации - Страница 38

38

Cleaning cycle

Press keys  

 and     repeatedly until the 

CLEANING cycle is selected. Press the key to confirm. 

(see chap. Description of cycles on p. 23).

The screen for setting the cleaning time, default 30 min, 

appears (from 20 min to 1h).

Press the keys     to increase or decrease the time by 

10 minutes at a time (hold down the keys to increase 

or decrease more quickly). Once the desired time is 

displayed, 

open the door

, press the key   to confirm 

and start the cycle.

During the cycle, the set time can be changed using the 

keys     . 5 minutes after starting the cleaning cycle, 

the spray symbol appears on the display and the beep 

sounds every 30 seconds to signal that the Irinox Clean 

neutral detergent must be sprayed inside the chamber. 

Spray the product over the entire internal surface, with 

the exception of the fan. After spraying the neutral 

detergent, do not close the door and press the key   

or wait 5 minutes to resume cleaning. Press the key   

for 2 seconds to stop the cycle and return to the cycle 

selection. At the end of the cleaning cycle, rinse the 

inside of the chamber thoroughly and dry carefully.

Beeeep

A cleaning cycle is recommended after every use. It is obligatory (to keep the 

appliance’s environment healthy) to run a cleaning cycle for a recommended time of 

30 minutes when switching from a cold cycle to a hot cycle, while keeping the door 

open at all times. Dry the inner walls and base of the chamber with a cloth. Wipe 

away any drops of water in the chamber at the end of the cleaning cycle to prevent 

mould or bad smells forming while the appliance is not used.

 It is advisable to keep the door ajar when FRESCO is not in use, to facilitate air 

circulation in the chamber and dissipate any leftover humidity.

 The inside of the chamber should be thoroughly rinsed and dried after cleaning.