Bosch ROTAK 43 LI 0.600.8A4.507 - Инструкция по эксплуатации - Страница 18

 English | 

17

Bosch Power Tools

F 016 L70 887 | (16.9.13)

Temperature Control Indicator

The red LED   signals that the battery or the electronics of the 

garden product (with battery inserted) are not within the op-

timum temperature range. When this occurs the garden prod-

uct will not operate or not at full capacity.

Temperature Control of the Battery

The red LED   flashes when pushing button   or pressing the 

On/Off switch   (when the battery is inserted): The battery is 

not wihin the temperature range for operation of  – 10 ° C to 

+ 60 ° C.
The battery switches off at a temperature above 70 ° C until 

the optimum temperature range is reached again.

Temperature Control of the Garden Product Elec-

tronics

The red LED   lights up 

continuously

 when pressing the 

On/Off switch  : The temperature of the garden product elec-

tronics is below 5 ° C or above 75 ° C.
At a temperature above 90 ° C, the electronics of the garden 

product switch off until the temperature is within the allowa-

ble temperature range again.

Area of Cut (Battery Duration)

The area of cut (battery duration) depends on lawn condi-

tions, grass density, mositure content, grass length and 

height of cut.
Switching the machine on and off frequently during cutting 

will also reduce the area of cut (battery duration).
To improve the area of cut (battery duration) it is recommend-

ed to cut more frequently, raise the cutting height and walk at 

a normal pace.
The example below shows impact of conditions against run 

time, for one battery.

To increase the run time an additional battery or higher capac-

ity battery (Ah) can be purchased from an authorised custom-

er service agent for Bosch garden products.

Troubleshooting

Cutting Conditions

Very light, dry grass

Light, dry grass

Area of cut

up to 450 m

2

up to 225 m

2

6cm

4cm

8cm

4cm

STOP

Problem

Possible Cause

Corrective Action

Machine fails to oper-

ate

Possible clogging

Remove the isolator key:

Check underneath the garden product and clear 

out as necessary (always wear gardening gloves)

Battery not fully charged

Battery Charging

Battery not inserted (properly) 

Inserting the battery

Grass too long

Increase height of cut and tilt garden product to re-

duce starting load

Motor protector has activated

Allow motor to cool and increase height of cut

Battery too hot/cold

Allow to cool/warm

Isolator key not inserted correctly/fully

Fit correctly

There is a short delay in the motor starting after en-

gaging the On/Off switch

Hold On/Off switch for 1 – 3 s to start motor

Motor starts and stops 

immediately

Battery not fully charged

Battery Charging

Isolator key not inserted correctly/fully

Fit correctly

Battery not inserted (properly) 

Inserting the battery

Battery too hot/cold

Allow to cool/warm
Increase height of cut

Machine functions 

intermittently

Internal wiring of garden product damaged

Contact Service Agent

Motor protector has activated

Allow motor to cool and increase height of cut

OBJ_BUCH-1954-003.book  Page 17  Monday, September 16, 2013  1:14 PM