Газонокосилки AL-KO EASY 5.1 SP-S 113607 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
GB
Translation of the original operating instructions
28
Petrol lawn mower
Do not start the unit if the discharge chute is not
covered by one of the following parts:
Grass catcher
%DIÀHSODWH
Mulch kit
Operate the starter switch with particular care ac-
cording to the manufacturer instructions
0DNHVXUH\RXUIHHWDUHDWDVXI¿FLHQWGLVWDQFH
away from the cutter unit.
Start the unit in low grass
Position indicators on the unit:
Choke*
Start Run Stop
Speed remote
control*
Start Stop
Speed remote
control, with
choke*
Vario gearbox*
Fast Slow
Blade clutch*
On Off
*depending on version
Manual starting
Without speed remote control, with choke
Choke
Start Run Stop
1. Set choke to position 1 (
13/1
).
2. Pull the safety bar to the upper bar and hold (
17
) – safety bar does not engage.
3. Pull the starter cord quickly and allow it to slowly
coil up again (
18
).
4. After the motor has warmed up (approx. 15-20
seconds), set the choke position 2 (
13/2
).
Starting the motor
Danger - risk of poisoning!
Never run the motor in enclosed spaces.
Danger - risk of injury!
Do not tip the unit during the starting procedure.
ƒ
Only start the motor with mounted blade (the
blade serves as centrifugal mass)
ƒ
When starting the warmed motor, do NOT use
the (HONDA) choke or primer button
ƒ
Do not modify the control settings on the motor
Inserting the side discharge
1. Remove the grass catcher and insert the mulch kit.
2. Fold open the cover for the side discharge and hold
¿UPO\
(
11/1
).
3. Insert the side discharge chute (
11/2
).
4. Slowly close the cover.
The cover secures the side discharge channel from
falling out.
Removing the side discharge
1. Fold open the cover for the side discharge and hold
¿UPO\
(
11/1
).
2. Remove the side discharge and close the cover (
11/2
).
Working height adjustment (option)
The working height can be adjusted to two different
heights, if needed.
1. Screw off both handle screws on the handle bar
¿WWLQJ
2. Pull out the threaded bolts and adjust to the desired
position by inserting into one of the two square
holes on the holders and through the bars (
12
).
Make sure that the same hole is used on each of
the holders!
3. Tighten the holders with the lower bar again using
the handle screws.
