Ecosoft P’URECALCIUM - Инструкция по эксплуатации - Страница 39

38

39

This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2021

ENG

REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE

8.

 TROUBLESHOOTING

PROBLEM

CAUSE

SOLUTION

Fitting leak

Tube is not joined tightly

Remove and rejoin the tube

Drain saddle leak

Drain saddle is not installed 

properly

Reinstall drain saddle as described in paragraph 

4.2 in this manual

Pre-filter sump leak

O-ring seal is lacking or misaligned

Check that the O-ring seal is properly aligned in the 

groove inside sump

Sump is not joined tightly

Tighten the sump till snug

Water runs too slowly from 

the faucet or slows down sub-

stantially a few seconds after 

the faucet is opened

Water supply pressure too low

This RO system requires at least 3 bar to function 

properly. If necessary, install a pressure booster 

pump or consult a plumber

Pre-filter cartridges are clogged

Replace pre-filter cartridges

Membrane is clogged

Measure permeate flowrate by closing tank valve 

6 and opening faucet 3. Use a measuring cup to 

check if the time it takes to produce 1 L drinking 

water is as follows:

– 8 minutes with 50 gpd membrane;

– 5-6 minutes with 75 gpd membrane;

– 4 minutes with 100 gpd membrane.

If it took twice as long or more to produce 1 liter 

of water, the membrane may need to be replaced 

(refer to the store where you bought this product)

A tube is kinked

Straighten the tube

Pressure tank is deflated

Pressure in the empty tank should be 0.4-0.6 bar 

(6-9 psi). Charge the tank to the above pressure

High noise

Air in the auto shut off valve

The air will go away by itself with continued 

operation of the system

Water supply pressure too high

Check your water supply pressure. If necessary, 

install a pressure regulator or refer to a plumber