Ecosoft P’URECALCIUM - Инструкция по эксплуатации - Страница 32

32

This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2021

REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE

1.

Turn off water supply to the system (feed valve 

5

), shut off the tank valve 

6

.

2.

Open the purified water faucet 3 to relieve permeate pressure. 

3.

4.

5.

Disconnect the white tube from the inlet in membrane housing cap. 

Unscrew the membrane housing cap.

Remove the used reverse osmosis membrane 

11

 (remember which end of the membrane goes where).  

6.

Lubricate rubber seals of the fresh replacement membrane and membrane housing cap sealing. 

CAUTION! To avoid damage to the membrane, only use food grade glycerol as lubricant.

7.

Install the fresh membrane into the housing, observing its direction and position of the tube.

CAUTION! Cut the plastic bag to install the reverse osmosis membrane. Install the membrane without first unpack

-

ing it by pushing it into the housing directly from the bag. Avoid touching the membrane and only hold it covered 

with the bag.

8.

Screw on the housing cap.

9.

Connect the white tube to the membrane housing inlet.

10.

Close drinking water faucet

 3

.

11.

Open the tank valve 

6

.

12.

Open the feed valve 

5

.

13.

Once  the  tank  is  full  (you  will  hear  the  water  stop  flowing),  drain  all  water  from  the  tank  into  the  sink  by  opening 

faucet 3. When the water stops running, close the purified water faucet 3 so that the tank starts to re-fill. Depending 

on the pressure in your water mains, filling may take 1.5 to 3 hours. After the second tank re-fill, you can safely use 

the purified water.

6. 

USAGE

6.3 THE PROCEDURE FOR REPLACING MEMBRANE

(membrane replacement should be performed by a qualified specialist)

Membrane

Cap of the membrane 

housin

White tube