Ecosoft P’URECALCIUM - Инструкция по эксплуатации - Страница 33

32

33

This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2021

ENG

REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE

6. 

USAGE

1.

Turn off water supply to the system (feed valve 

5

), shut off the tank valve 

6

.

2.

Open the purified water faucet 

3

 to relieve permeate pressure.  

3.

4.

5.

6.

7.

Disconnect the tubes that connect the carbon post filter / mineralizing 

post-filter to the rest of the system (remember which goes where).

Remove the used carbon post-filter / mineralizing post-filter from clip 

brackets. 

Install new carbon post-filter / mineralizing post-filter, guided by arrows 

that indicate the direction of water flow. 

Connect the tubes to the new carbon post-filter / mineralizing post-fil-

ter to connect it to the system. 

Open feed valve 

5

. Open tank valve 

6

.

9.

Once  the  tank  is  full  (you  will  hear  the  water  stop  flowing),  drain  all  water  from  the  tank  into  the  sink  by  opening 

faucet 

3

.  When  the  water  stops  running,  close  the  purified  water  faucet 

3

  so  that  the  tank  starts  to  re-fill. 

Depending on the pressure in your water mains, filling may take 1.5 to 3 hours. After the second tank re-fill, you can safely 

use the purified water.

In  the  models  of  filters  with  a  mineralizing  post-filter  the  purified  water  can  be  slightly  turbid  after  installation.  Drain 

several additional tanks of purified water.

6.4 THE PROCEDURE FOR REPLACING CARBON POST-FILTER AND/OR 

       MINERALIZING POST-FILTER

6.5 THE PROCEDURE FOR REPLACING UV LAMP

        (UV lamp replacement should be performed by a qualified specialist)

Recommended life of the UV lamp is 9000 hours (approximately 1 year of continuous operation).

CAUTION! 

Using  UV  lamp  beyond  the  recommended  service  life  is  disapproved,  since  the  intensity  of  UV 

radiation and its germicidal efficiency will be reduced.

It is strongly forbidden to turn on the UV lamp power when the lamp is not in metal housing, and 

to look at a glowing lamp. This can lead to eye damage and result in deterioration or loss of vision.

When replacing the UV lamp, it is advisable to clean the quartz sleeve. Do not use abrasive mate-

rials to clean the sleeve, as this may decrease transparency of the sleeve to UV radiation, thereby 

reducing the efficiency of disinfection. Be careful when removing the quartz sleeve from the housing 

to avoid damaging or scratching the sleeve.