Kuppersberg HO 658 W - Инструкция по эксплуатации - Страница 9

16

17

Technical passporT

english

english

Technical passporT

electric oven

electric oven

C l e a N i N G  a N D 

m a i N t e N a N C e

By  ensuring  proper  cleaning  and 

mainte nance  of  your  cooker  you  can 

have  a  sig nifi cant  infl uence  on  the 

continuing  fault-free  operation  of  your 

appliance.

before you start cleaning, the cooker 

must be switched off and you should 

ensure that all knobs are set to the 

position “off”. Do not start cleaning until 

the cooker has completely cooled.

Oven



The oven should be cleaned 

after every use. When cleaning the oven 

the  lighting  should  be  switched  on  to 

enable you to see the surfaces better.



The oven chamber should only 

be washed with warm water and a small 

amount of washing-up liquid. 



After cleaning the oven chamber 

wipe it dry.



Steam Cleaning function: 



-pour 250ml of water (1 glass) 

into a bowl placed in the oven on the 

fi rst level from the bottom, 



- close the oven door, 



-  set  the  temperature  knob 

to  50°C,  and  the  function  knob  to  the 

bottom heater position 



- heat the oven chamber for 

approximately 30 minutes, 



- open the oven door, wipe 

the chamber inside with a cloth or 

sponge  and  wash  using  warm  water 

with washing-up liqu id. , 



After cleaning the oven chamber 

wipe it dry.

Caution! 

Do  not  use  cleaning  products 

contain ing  abrasive  materials  for  the 

cleaning  and  maintenance  of  the  glass 

front panel.

important! 

Do not use any abrasive agents, 

harsh detergents or abrasive ob jects for 

cleaning.

Only use warm water with a small 

amount of dishwashing liquid to clean 

the front of the appliance. Do not use 

washing powders or creams.



Ovens  in  cookers  marked  with 

the letter D are equipped with easily 

removable wire shelf supports. To 

remove them for washing, pull the front 

catch, then tilt the support and remove 

from the rear catch.

Removing wire shelf supports

Installing wire shelf supports

Door removal

In order to obtain easier access to 

the  oven  chamber  for  cleaning,  it  is 

possible to remove the door. To do this, 

tilt  the  safety  catch  part  of  the  hinge 
upwards  (fi g.  A).  Close  the  door  lightly, 

lift and pull it out towards you. In order 

to fi t the door back on to the cooker, do 
the inverse. When fi tting, ensure that the 
notch of the hinge is correctly placed on 
the protrusion of the hinge holder. After 
the door is fi tted to the oven, the safety 

catch should be carefully lowered down 

again.  If  the  safety  catch  is  not  set  it 
may  cause  damage  to  the  hinge  when 
closing the door.

Tilting the hinge safety catches

removing the inner panel

1.  Using  a  fl at  screwdriver  unhook 

the  up per  door  slat,  prying  it  gently  on 
the sides (fi g. B).

2. Pull the upper door slat loose. (fi g. 

B, C)