Timberk SWH RED3 80 V - Инструкция по эксплуатации - Страница 8

www.timberk.com • electrical storage water heater

7

Water heater mounting 

NOTE:

Please, use accessories, provided by the 

manufacturer, to install the water heater. Electric 

water heater must not be mounted on a wall prior 

you make sure that the bracket is installed firmly and 

securely. Otherwise the electric water heater may fall 

down from the wall, which may cause its damage and 

even serious accidents involving bodily injury. When 

determining points for bolt holes, it is necessary to 

provision some spare space between the lower part 

of the water heater and the floor not less than 0.6 

m, to make it convenient to perform maintenance if 

necessary.

NOTE:

In places or on the wall, where there may be a water 

contact, the power outlet installation height must be 

not less than 1.8 m.

Connection to water main

1. The heater must be connected to water main with at least 0.1 MPa 
pressure; maximum pressure is 0.75 MPa.

1. The electric water heater must be mounted on a solid wall. If wall strength 
doesn’t allow to bear the double weight of the total water heater weight 
fully filled with water, then it should be mounted on a special support.

2. After you chose the proper place to install the water heater, determine 
points for holes for anchor hook bolts (to be determined in accordance 
with the data sheet for the appliance you chose). Drill two holes of the 
corresponding depth in the wall using a drill, dimensionally fit for anchor 
bolts, enclosed with the water heater.

Fig. 7

Then insert bolts into the drilled holes, and, turning bolt hooks clockwise, 
securely tighten bolt nuts, then hang the water heater on these anchor bolt 
hooks (see Fig. 7).

3. Fix a power outlet to the wall. Requirements to the outlet are as follows: 
220V/10A, single-phase, three-wired. It is recommended to place the 
outlet on the right side above the water heater.

NOTE:

The water heater is an appliance, operating in such 

a manner that pressure of water in the water heater 

corresponds to the pressure of water in water main. 

If pressure in the main exceeds 0.75 MPa, then it is 

necessary to mount a pressure reducer before the water 

heater so that pressure doesn’t exceed 0.75 MPa.

2. G1/2 diameter pipes are used to connect the water heater to the water 
pipeline.

3. To prevent a leakage when connecting pipes, use rubber sealing gaskets 
on the threaded pipe ends.

4. Screw a relief valve to the inlet nozzle, marked blue and embossed arrow 
of the water flow direction, so that the water flow direction coincides with 
direction of the arrow on the valve’s case.