Timberk SWH FSL3 100 VH - Инструкция по эксплуатации - Страница 10

www.timberk.com • electrical storage water heater

10

9. MAINTENCE

Fig. 9

Fig. 10

1. Check the power plug and outlet as often as possible. Secure electrical 

contact and also proper grounding must be provided. The plug and outlet 

must not heat excessively.
2. If the water heater is not used for a long time, especially in regions with 

low air temperature (below 0°C), it is necessary to drain water from the 

heater .
3. To ensure long reliable water heater operation, it is recommended to 

regularly clean the internal tank and remove deposits on the electric heating 

element of the water heater, as well as check condition of the magnesium 

anode and, if necessary, replace it with a new one.

4. Preventive operations must be performed upon strict observance of the 

operation manual and safety precautions.
5. The water heater is equipped with a thermal switch, which cuts off power 

supply of the heating element upon water overheating or its absence in the 

water heater. If the water heater is connected to the mains, but water is 

not heated and the indicator doesn’t light up, then the thermal switch was 

IMPORTANT! 

The manufacturer provides an extended guarantee 

for particular water heater components provided that 

timely and proper routine maintenance is performed 

by specialists of an authorized service center (see the 

guarantee card).

NOTE:

When setting temperature, having reached the 

optimal heating position “        ” (+58°С (+/- 2°С), you 

will hear a sound signal (for some models).

1.2 Plug the power cord into the outlet, at that an indicator light on control 

panel. 

2. Water heating temperature setting

2.1. Temperature can be set within the range 35°С-75°С, in increments 

of 1°С.

2.2 The water heater automatically maintains water temperature. When 

water temperature in the water heater reaches the temperature, set by the 

NOTE:

During normal operation the cold water supply valve 

must be set “open”.

user, the heating is automatically switched off.  When water temperature 

in the water heater drops to a certain level, the heating is automatically 

switched off.

IMPORTANT! 

Water may start dripping from the relief valve hole 

during heating. It is impossible to avoid water leakage 

and you must not prevent it since valve blocking 

may cause rupture of the internal tank (in case of 

equipment failure).