Vestel VH64E222B - Инструкция по эксплуатации - Страница 37

EN - 16

heat setting.

If a timer was associated with the heater, 

“

00

” will be shown on the timer display for 

10 sec. After this, the timer display turns off.

After a heater has been automatically 

turned off, as described above, the heater 

can be used and the maximum operating 

time for this heat setting is applied.

Residual Heat Functions

After all cooking processes there is some 

heat stored in the vitroceramic glass 

called residual heat. The appliance can 

calculate roughly how hot the glass is. If 

the calculated temperature is higher than 

+ 60 °C, then this will be indicated in the 

corresponding heater display. After the 

heater or the hob control has been turned 

off, the residual heat display is shown as 

long as the calculated heater temperature is 

> + 60 °C.

The residual heat indicator has the lowest 

priority and is overwritten by every other 

display value and during safety switch offs 

and the displaying of error codes. When 

voltage is supplied to the hob after a power 

interruption, the residual heat display 

indicator flashes. If a heater had a residual 

heat of greater + 60 °C before the power 

interruption occurred, the display will flash 

while the residual heat remains or until 

the heater is selected for another cooking 

operation.

Hints and Tips 

Important:

When ceramic heaters are 

operated in higher heat settings, the 

heated areas may be seen switching 

on and off. This is due to a safety device, 

which prevents the glass from overheating. 

Some switching on and off when cooking at 

high temperatures is quite normal, causes 

no damage to the hob and little delay in 

cooking times.

WARNING:

•  Never operate the hob without pans on 

the cooking zone. 

•  Use only flat saucepans and with a 

sufficiently thick base. 

•  Make sure the bottom of the pan is dry 

before placing it on the hob.

•  While the cooking zone is in operation, 

it is important to ensure that the pan is 

centred correctly above the zone.

•  In order to conserve energy, never use a 

pan with a different diamater to hotplate 

being used. 

Circular Saucepan 

Base

Small Saucepan 

Diameter

Saucepan base that 

has not settled

•  Do not use saucepans with rough 

bottoms since these can scratch the 

glass ceramic surface. 

•  If possible, always place lids on the 

pans. 

•  The temperature of accessible parts 

maybe high when the appliance is 

operating. Keep children and animals 

well away from the hob during operation 

and until it has fully cooled after 

operation.

•  If you notice a crack on the cook top 

it must be switched off immediately 

and replaced by authorised service 

personnel.

4.2 aCCeSSorieS

The Vitroceramic Glass Spatula

Always use the glass spatula to remove 

spillages or deposits from the hob before 

trying chemical cleaning agents. This is 

the ideal method for removing even the 

smallest deposits from the hob, and for 

removing spillages from hot cooking zones 

before they burn onto the hob.

Important:

 Always push the safety 

cover back over the razor blade after use. 

Take care when using the spatula and keep 

it out of the reach of children.