Vestel VH64E222B - Инструкция по эксплуатации - Страница 36

EN - 15

heater displays show “

L

” as confirmation.

If the minute minder is still running, it will 

proceed until ´

00

` is reached and the 

timer will beep. After confirmation of timer 

completion, the appliance is fully locked. 

None of the buttons can be used as long as 

the appliance is locked.

Child lock can be deactivated in the same 

way that it is activated. After pressing 

a beep is heard, 

 and 

 have to be 

pressed simultaneously for at least 0.5 

seconds, followed by pressing only  . As 

confirmation for successful unlocking, “

L

” 

will no longer be displayed.

Touch Control Safety Functions 

The following safety functions are available 

to avoid unintended operations 

Sensor Safety Cut Off

To prevent the appliance from unwanted 

button operation, button monitoring is 

included. In cases where one or more 

buttons are pressed for longer than 12 

seconds, there is an audible noise to 

indicate an incorrect operation (pot or other 

object placed on the button, sensor failure, 

etc.) and the appliance switches off.

The safety turn off causes the hob to go 

into S-Mode. An “

F

” will flash in all heater 

displays.

If residual heat is present, it will be 

displayed in all other heater displays.

The hob control will then go into S-Mode. 

At the same time a buzzer sounds. After 10 

minutes the buzzer will stop.

If there is no erroneous operation present, 

both the visual and the audible signals will 

disapear.

Over Temperature Switch Off

Due to the controls being very close to the 

heater in the middle of the front of the hob, 

it can occur that an incorrectly placed pot is 

not sensed by the sensor safety cut off (not 

covering a button) and heats up the hob to 

a very high temperature, which makes the 

glass and the buttons dangerous to touch.

To prevent the hob control unit from 

damage, the controls constantly monitor the 

temperature and switches off if overheating 

occurs.

This is indicated with the letter “

t

” in 

the heater display until the temperature 

decreases.

Once the temperature has dropped, the “

t

” 

in the heater display will be cleared and the 

hob control unit reverts back into S-Mode. 

This means that the user can reactivate the 

appliance by pressing   .

Operating Time Limitations

The hob control unit has a limitation on 

the operating time. If the heat setting for a 

heater has not been changed for a certain 

time, the heater will turn off automatically 

(for 10 sec a “

0

” is displayed. Some 

residual heat may be present). The limit of 

the operating time depends on the selected