Fulgor Milano CPH 401 BQ TC X - Инструкция по эксплуатации - Страница 16

16

17

GB

Installation

These instructions are provided for qualified installers as 
a guide to installation, adjustment and maintenance in 
conformity with current laws and standards. Service must 
always be performed with the appliance disconnected 
from the electricity.

Operation (Fig. 3 and 4)

The appliance is designed to be built in to a work surface 
as shown in the figure. Prepare the edge of the hob with 
the sealant provided (Fig. 5).

Electrical connection 

Before connecting to the electricity, make sure that:
-  the characteristics of the system match the data on 

the bottom of the hob;

- the system has an effective earth connection 

compliant with current standards and laws. An earth 
connection is required by law.

-  If the appliance has no cable and/or plug, use 

material suitable for the absorption indicated on the 
registration plate and for the working temperature. 
The cable must not reach a temperature higher than 
50 °C above room temperature in any point. 

- For direct connection to the mains, it is necessary 

to provide a device that ensures disconnection from 
the mains, with an open distance of the contacts that 
allows complete disconnection under Category III 
conditions, conforming to the installation rules.

-  The omnipolar plug or switch must be easy to reach 

when the appliance is installed.

- The appliance is NOT intended for use with an 

external timer or a separate remote control system.

-  If it is necessary to replace the power cord of the fryer, 

use only an oil-resistant type H05RN-F or H07RN-F 
cable.

- If it is necessary to replace the power cord of the 

barbecue, use an H05RR-F type cable or equivalent.

Note: The manufacturer declines all liability if the 
usual accident prevention standards and the above 
instructions are not followed. 

Installation instructions