Варочная панель Simfer H30I12B011 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
18
GB
•Immediately after the selection of the timer, the relevant LED will flash
and the point in the timer indicator will flash continuously. If a cooking
surface is selected after that, the point will be lost and the flashing of the
LED indicator will stop.
•While passing from one cooking surface to the other, the timer indicator
will show the current timer period of the relevant cooking surface. Timer
settings of other cooking surfaces will remain active.
•Further adjustments are similar to those of the independent timer.
•In case there is more than one active timer, the indicator will show the
lowest timer value (following the 10 seconds period for cancelling the
selection).
•At the end of the adjusted time, an acoustic signal will be given and the
timer indicator will flash as ‘‘00’’. The LED indicator of the relevant timer
will also flash on a simultaneous basis. The programmed cooking surface
will be interrupted, a continuous ‘‘0’’ will be shown and the cooking sur-
face will be selected automatically. At the end of the 10 seconds (time for
cancelling the selection) ‘‘H’’ will be shown by being continuously illumi-
nated in the ‘‘hot’’ cooking zone. Otherwise, the symbol will be ‘‘0’’.
•The acoustic signal and the flashing of the LED indicator of the cooking
zone timer
- will be ended by activating any button
- after 2 minutes.
After that the timer indicator will stop and disappear and the cooking
surface will remain as unselected.
The behavior of the cooking zone-specific timer is similar to that of the
independent timer.
In case there is a timer programmed for a cooking surface, the operation
time limitation will be dependent on the timer value and it will be inde-
pendent from the standard table value.
The precision of the timer value will depend on the precision of the
∞
C
clock and may display a deviation of ‘‘+/- 4 %’’ in 99 minutes.
Adjusting the Timer Value:
•Select the timer indicator (by touching the indicator zone)
