Варочная панель Simfer H30I12B011 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
15
GB
•Selected power level (‘‘0’’ to ‘‘9’’)
•On/Off times of relays
The idle temperature indicator of each cooking surface will remain active
until the measured temperature becomes lower than + 60 °C.
Automatic Turn-Off (Operation Time Limitation)
A maximum operation time is defined for each active cooking surface.
The maximum operation time depends on the selected cooking level. The
cooking surface will be turned off automatically after the maximum oper
-
ation time expires.
Each activation in the cooking surface (changing the cooking level, etc.)
will bring the count-down timer to its initial value.
When the timer comes to the end and this is not demanded by automatic
turn-off (for instance, a timer of 99 minutes for cooking level 9), the set-
tings of the timer will have priority against the high cooking level settings
(for instance; the cooking surface will pass on to stop mode).
Protection against Involuntary Activation
•In case the continuous use of buttons is detected for a period of around
10 seconds, the electronic system will be cut off automatically. The con-
trol unit will spread an audible signal throughout this dysfunction of 10
seconds (period: 1000 msec, 500 msec ON) and the error code ‘‘E R 0
3’’ will flash on the indicator (0.5 sec ON 0.5 sec OFF). If permanent ac
-
tivation exceeds 10 seconds, the error code ‘‘ER 03’’ will continue to flash
as long as the error continues and is identified. If the cooking surface is
in ‘‘hot’’ state, the symbol ‘‘H’’ and the error code will flash in alternation
(0.5 sec Error Code, 0.5 sec ‘‘H’’).
•Water spilt on the glass surface shall not necessarily cause a button to
be activated and may not always be accurately detected. (All buttons will
immediately be ready for use after the water on the buttons is wiped off).
•In none of the cooking surfaces becomes activated within 20 sec
-
onds after pressing the ‘‘POWER ON’’, the control unit will pass on to the
‘‘Turned-Off Mode’’ (black indicator).
Reaction Time of Sensor Buttons
The reaction time of sensor buttons has been fixed as follows:
•‘Delay for ‘Button Power Off’, delay for ‘‘Power On’’
