Kuppersberg TS 69 W - Инструкция по эксплуатации - Страница 12

12

Technical passporT

english

gas hob

Figure 6.

RIGHT

WRONG

Â

In order that the hob will 

operate properly the grills and burner 
components should be properly 
positioned.(Figure 1) 

Â

Make sure that the flame of your 

burner is in blue color and work quietly. 
If the burner will burn in yellow color 
or work with voice make sure that all 

burners  fit  properly.  If  the  flame  color 

does not change to blue color then 
apply the authorized service.

After realization of the hob, 

complete the conversion transaction 
by connecting the rubber seals and 
switched in the same order. 

These instructions should be 

used by an authorized service. The 
products should be installed as per 
the regulations in force and in proper 
manner. Before conducting any 
transaction the electrical connections 
of the hob should be cut by no means. 

The type label on the hob indicates 

the gas type planned to be used with 
the unit.

6.6. STARTING THE APPLIANCE 
FIRING OF BURNER 

If your hob does not have built in 

lighter or during black out place the 

naked  flame  over  the  burner  and  push 

the switch to bring it to the desired 
position with counter-clockwise 
movement. 

Gas adjustment should 

be  between  maximum  and  minimum 
levels, it should not be realized between 
maximum and off positions. 

To close the 

burner turn the switch clockwise till to 
reach “off”  position. 

MODELS EQUIPPED WITH 

LIGHTER SWITCH (Automatic 

ignition) 

In order to burn one of the burners, 

press the switch down and bring the 
switch to maximum position. When it 

burns,  flame  is  adjusted  to  the  desired 

intensity with the switch.