Kuppersberg TS 69 W - Инструкция по эксплуатации - Страница 10

10

Technical passporT

english

gas hob

Counter

Gasket

Installation Clamp

Figure 4.

Installation Clamp

Figure 5.

6.3. ELECTRIC CONNECTION 

Â

Electric connection should 

be conducted by a competent and 
authorized person. 

Â

The electric cable of your hob 

should not be laid at hot regions. 

Â

When the power cable is 

damaged this cable should be changed 
with a special cable to be supplied by a 
special cable agency or the authorized 
service dealer. 

Â

No reducer, adapter, and switch 

should be used for electrical connection 
since it will cause excessive heat and 

fire. 

Â

Plug the electric cable to a 

grounded wall socket. The manufacturer 
hereby declares that it will be released 
all liability in the event of any failure in 
this issue. 

Â

The supply data of the electric 

network should be suitable with the 
data on the type label of the unit.

6.4. GAS CONNECTION 

These instructions are prepared for 

specialist personnel having 

required 

competence, the installation of the 

equipment 

should be suitable as per 

the applicable standards. 

All gas related works should be 

conducted when the electric connection 

was cut. 

The value plate on the hob indicates 

the gas type intended to be used for use 

with the hob. Connection to the main 

gas course or gas type shall be realized 

after controlling the adjustment as 

per the gas type. Connection to the 

main gas source or gas cylinder shall 

be conducted after checking the 

adjustment according to the proper 

gas type. If it is set properly look at the 

following paragraphs: 

Note that the LPG hoods should 

have standarts stamp and 300 mmSS 

(30mbar) of outlet pressure. 

Natural gas pressure is 200 mmSS 

(20mbar). Please consult the authorized 

service for conversion to natural gas or 

LPG. 

Use only piping, gaskets or stamp as 

per the applicable national standards. 

In some countries where conic 

connections are obligatory, conic 

connection is provided. In such a case 

the conic connection part should be 

connected to the unit.

If the unit will be connected to a 

flexible  hose,  the  length  of  the  hose 

shall not exceed 120 cm. 

Before starting works related to gas 

installation, please cut the gas supply.