Philips GC4890/02 - Инструкция по эксплуатации - Страница 16

Guarantee and service 

If you need information or if you have a problem, please visit the Philips 

website at 

www.philips.com 

or contact the Philips Consumer Care 

Centre in your countr y (you find its phone number in the worldwide 

guarantee leaflet). If there is no Consumer Care Centre in your countr y, 

go to your local Philips dealer. 

Troubleshooting

If the appliance does not work or does not work properly, first check 

the list below. If the problem is not mentioned in this list, the appliance 

probably has a defect. In that case we advise you to take the appliance to 

your dealer or to an authorised Philips ser vice centre.

Problem

Possible cause

Solution

The iron is plugged 

in, but the soleplate 

is cold.

There is a connection 

problem.

Check the mains cord, the plug and the wall 

socket.

The temperature dial is set 

to MIN.

Set the temperature dial to the required 

position.

The iron does not 

produce any steam.

There is not enough water in 

the water tank.

Fill the water tank (see chapter ‘Preparing for 

use’, section ‘Filling the water tank’).

The steam control is set to 

position 0.

Set the steam control to a position between 1 

and 6 (see chapter ‘Using the appliance’, section 

‘Steam ironing’).

The iron is not hot enough 

and/or the drip-stop function 

has been activated.

Set an ironing temperature that is suitable for 

steam ironing ( 

2

 to MAX). Put the iron on 

its heel and wait until the temperature light has 

gone out before you star t ironing.

The iron does not 

produce a steam 

boost.

You have used the steam 

boost function too often 

within a ver y shor t period.

Continue ironing in horizontal position and 

wait a while before you use the steam boost 

function again.

The iron is not hot enough.

Set an ironing temperature at which the steam 

boost function can be used ( 

3

 to MAX). 

Put the iron on its heel and wait until the 

temperature light has gone out before you use 

the steam boost function.

ENGLISH

16