Yamaha RX-V665 - Инструкция по эксплуатации - Страница 14

12

 En

Connections

■

Connecting to the FRONT, CENTER, 
SURROUND and SURROUND BACK/BI-AMP 
terminals

1

Remove approximately 10 mm (0.4 in) of 
insulation from the end of each speaker 
cable and then twist bare wires of the cable 
together so that they will not cause a short 
circuits.

2

Loosen the knob, insert the twisted bare 
wires into the hole, and then tighten the 
knob.

■

Connecting to the EXTRA SP terminals

1

Press down the tab and insert the bare end of 
the speaker cable into the hole in the terminal.

y

•

You can connect the presence speakers (see page 11) or the speakers in 
the second zone (Zone2) (see page 50) to EXTRA SP terminals.

2

Release the tab to secure the wire.

You can connect speakers that support bi-amplification 
connections to this unit. To connect the speakers via a bi-
amp connection, connect them to the FRONT jacks and 
SURROUND BACK/BI-AMP terminals as illustrated. 
To enable the bi-amp connection, connect the power cable 
to the wall outlet, display the ADVANCED SETUP menu 
and set “BI AMP” to “ON” (see page 55).

Connecting the speaker cable

Caution

•

A speaker cable is a pair of insulated cables running side by side in general. One of the cables is colored differently 
or striped to indicate a polarity. Connect one end of the colored/striped cable to the “+” (red) terminal of this unit 
and the other end to that of your speaker, and connect one end of the other cable to the “–” (black) terminal of this 
unit and the other end to that of your speaker.

•

Before connecting the speakers, be sure to disconnect the power cable.

•

Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or 
speakers. If the circuit shorts out, “CHECK SP WIRES!” appears on the front panel display when this unit is turned 
on.

•

Use magnetically shielded speakers. If images on the monitor are still distorted even when you use the magnetically 
shielded speakers, place the speakers away from the monitor.

•

Use speakers with an impedance of 6-ohm or larger. 

Connecting the banana plug (Except Russia 
and Asia models)

Tighten the knob, and then insert the banana plug into 
the end of the terminal.

10 mm (0.4 in)

1

2

3

Red: positive (+)

Black: negative (–)

Banana plug

Using bi-amplification connections

Caution

Before making bi-amplification connections, remove 
any brackets or cables that connect a woofer with a 
tweeter. Refer to the instruction manuals of speakers for 
details. 
When not making bi-amplification connections, make 
sure that the brackets or cables are connected before 
connecting the speaker cables.

Red: positive (+)

Black: negative (–)

SURROUND BACK/

BI-AMP

FRONT

Front speakers

Right

Left

This unit