Husqvarna 325R 9679084-02 - Инструкция по эксплуатации - Страница 15

5. Put the locknut (H) on the output shaft. Hold the

shaft of the combination wrench near the cutting

attachment guard. Turn the combination wrench

counterclockwise to tighten the locknut. Torque the

locknut to 35-50 Nm / 26-36 ft/lb.

6. Remove the locking pin.

To attach the trimmer head

1. Make sure that the cutting attachment guard (A) is

attached to the product. Refer to 

To assemble the

cutting attachment guard on page 14. (Fig. 31)

2. Make sure that the drive disc (C) is attached to the

output shaft (D).

3. Put the locking pin (B) in the hole to lock the shaft.
4. Put the trimmer head (E) on the output shaft.
5. Turn the trimmer head counterclockwise to tighten it

to the output shaft. (Fig. 32)

6. Remove the locking pin.

Operation

Introduction

WARNING: Before you operate the product,

you must read and understand the safety

chapter.

Fuel

This product has a two-stroke engine.

CAUTION: Incorrect type of fuel can result

in engine damage. Use a mixture of gasoline

and two-stroke oil.

Premixed fuel

• Use Husqvarna premixed alkylate fuel of a good

quality, for best performance and extension of the

engine life. This fuel contains less harmful chemicals

compared to regular fuel, which decreases harmful

exhaust fumes. The quantity of remains after

combustion is lower with this fuel, which keeps the

components of the engine more clean.

To mix fuel

Gasoline

CAUTION: Do not use gasoline with an

octane number less than 90 RON (87 AKI).

This can cause damage to the product.

CAUTION: Do not use gasoline with more

than 10% ethanol concentration (E10). This

can cause damage to the product.

• Always use new unleaded gasoline with a minimum

octane number of 90 RON (87 AKI) and with less

than 10% ethanol concentration (E10).

• Use gasoline with a higher octane number if you

frequently use the product at continuously high

engine speed.

Two-stroke oil
• For best results and performance use Husqvarna

two-stroke oil.

• If Husqvarna two-stroke oil is not available, use a

two-stroke oil of good quality for air-cooled engines.

Speak to your servicing dealer to select the correct

oil.

CAUTION: Do not use two-stroke oil for

water-cooled outboard engines, also

referred to as outboard oil. Do not use oil

for four-stroke engines.

To mix gasoline and two-stroke oil

Gasoline, liter

Two-stroke

oil, liter

2% (50:1)

5

0.10

10

0.20

15

0.30

20

0.40

CAUTION: Small errors can influence the

ratio of the mixture drastically when you mix

small quantities of fuel. Measure the quantity

of oil carefully and make sure that you get

the correct mixture.

(Fig. 33)
1. Fill half the quantity of gasoline in a clean container

for fuel.

2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the

container.

5. Carefully shake the fuel mixture.

881 - 001 - 10.10.2018

15