Sparky VC 1530SP - Инструкция по эксплуатации - Страница 14

12

VC 1530SP • VC 1530SA • VCM 1530SP • VCM 1530SA

EN

fault

probable cause

Remedy

Motor does not start

A fuse of the mains socket has 

blown.

Connect the mains fuse.

The overload protection switch has 

tripped.

Switch off the vacuum cleaner and allow it to cool for 

approx. 5 minutes. If the cleaner cannot be started 

again, contact a SPARKY service centre.

The motor is faulty.

Have the motor changed by a SPARKY service 

centre.

Motor does not run in 

automatic mode

The power tool/pneumatic tool is 

defective or not connected properly.

Check that the power tool is functioning or that the 

plug is inserted correctly into the built-in socket.

The power rating of the power tool 

is too low.

Note that minimum power rating P>40W.

Reduced suction 

power

The suction power selected with suc-

tion power control is too low.

Set suction power in accordance with section „Suc-

tion power control“.

Clogged suction hose/nozzle.

Clean hose/nozzle

The tank, disposal bag or filter bag 

is full.

Refer to "Emptying the tank" or "Replacing the 

disposal bag",

The filter element is clogged.

Refer to "Cleaning the filter" or "Replacing the PET 

cartridge filter".

The seal between tank and upper 

section of vacuum cleaner is faulty 

or missing.

Replace the seal.

The cleaning system is defective.

Contact a SPARKY service centre.

The alarm sounds 

(reduced suction 

power)  

(Models  

VCM 1530SP, 

VCM 1530SA only)

The suction power selected with 

switch (4) is too low.

Increase the suction power. Refer to section "Suc-

tion power control".

The hose diameter does not corre-

spond to the switch (12) position.

Set the correct switch position.

Clogged suction hose/nozzle.

Clean the suction hoze/nozzle.

The tank, disposal bag or filter bag 

is full/

Refer to sections "Emptying the tank", "Replacing 

the disposal bag", "Replacing the fleece filter bag".

The filter element is clogged.

Refer to sections "Cleaning the filter" and "Replacing 

the filter"

The seal between the tank and the 

upper section is faulty or missing.

Replace the seal.

The cleaning mechanism is faulty.

Contact a SPARKY service centre.

No suction power 

during wet cleaning

The tank is full.

Switch off the vacuum cleaner. Empty the tank.

Voltage fluctuations

Impedance of power supply is too 

high.

Connect the vacuum cleaner to another socket 

closer to the fuse box. Voltage fluctuations over 7% 

should not occur if the impedance at the transfer 

point is ≤ 0.15 Ω.

tRoUblEsHootING