Makita DHP482RFE3 - Инструкция по эксплуатации - Страница 5

5

ENGLISH

CAUTION:

Always install the battery cartridge 

fully until the red indicator cannot be seen.

 If not, 

it may accidentally fall out of the tool, causing injury to 

you or someone around you.

CAUTION:

Do not install the battery cartridge 

forcibly.

 If the cartridge does not slide in easily, it is 

not being inserted correctly.

Battery protection system

Lithium-ion battery with star marking

1

1. Star marking

Lithium-ion batteries with a star marking are equipped 

with a protection system. This system automatically 

cuts off power to the tool to extend battery life.

The tool will automatically stop during operation if the 

tool and/or battery are placed under one of the following 

conditions:

Overloaded:

The tool is operated in a manner that causes it to draw 

an abnormally high current.

In this situation, release the switch trigger on the tool 

and stop the application that caused the tool to become 

overloaded. Then pull the switch trigger again to restart.

If the tool does not start, the battery is overheated. 

In this situation, let the battery cool before pulling the 

switch trigger again.

Low battery voltage:

The remaining battery capacity is too low and the tool 

will not operate. In this situation, remove and recharge 

the battery.

Indicating the remaining battery 

capacity

Only for battery cartridges with "B" at the end of the 

model number

1

2

1. Indicator lamps    2. Check button

Press the check button on the battery cartridge to indi-

cate the remaining battery capacity. The indicator lamps 

light up for few seconds.

Indicator lamps

Remaining 

capacity

Lighted

Off

Blinking

75% to 100%

50% to 75%

25% to 50%

0% to 25%

Charge the 

battery.

The battery 

may have

malfunctioned.

NOTE:

 Depending on the conditions of use and the 

ambient temperature, the indication may differ slightly 

from the actual capacity.