TP-LINK ARCHER GX90 AX6600 - Инструкция по эксплуатации - Страница 78

74

Chapter 12

Customize Your Network Settings

Network Destination: 

The destination IP address that you want to assign to a static 

route. This IP address cannot be on the same subnet with the WAN IP or LAN IP of 
Router A. In the example, the IP address of the company network is the destination 
IP address, so here enter 172.30.30.1.

Subnet Mask:

 Determines the destination network with the destination IP address. 

If the destination is a single IP address, enter 255.255.255.255; otherwise, enter 
the subnet mask of the corresponding network IP. In the example, the destination 
network is a single IP, so here enter 255.255.255.255.

Default Gateway:

 The IP address of the gateway device to which the data packets 

will be sent. This IP address must be on the same subnet with the router’s IP which 
sends out data. In the example, the data packets will be sent to the LAN port of 
Router B and then to the Server, so the default gateway should be 192.168.0.2.

Interface:

 Determined by the port (WAN/LAN) that sends out  data packets. In the 

example, the data are sent to the gateway through the LAN port of Router A, so 

LAN

should be selected.

Description:

 Enter a description for this static routing entry.

5  

Click 

SAVE

.

6  

Check the 

Routing Table

 below. If you can find the entry you’ve set, the static routing 

is set successfully.

Done!