DREAME Bot Auto-Empty Robot Vacuum And Mop Z10 Pro Black (RLS5D) - Инструкция по эксплуатации - Страница 10

14

15

EN

EN

Clean the Dust Bin

Routine Maintenance

1. Open the robot cover, then press the dust 

bin clip to remove the dust bin.

2. Open the bin cover and empty the 

bin as shown in the diagram.

3. Remove the filter and tap its basket gently.

5. Rinse the dust bin and filter with water until they are clean. Thoroughly dry the filter before re-

installing.

4. Clean the dust intake.

Note: 

Do not attempt to clean the filter with a 

brush or finger.

Note:

• Rinse the filter with clean water only.Do not use detergent.
• Before using, keep it in a well-ventilated or cool place.

Clean the Mopping Module

Routine Maintenance

1. Press the two release clips on the side of the water tank, remove the 

mopping module, and pull the mop pad off the mopping module.

3. Clean the mop pad with water only and leave to air dry before re-installing.

 2. Pour out the water in the tank. Clean with only water and leave out to air 

dry before re-installing.

4. If slow water flow occurs, or the volume is not well-distributed, clean the air 

hole in the cover of the water tank.

Note: 

Do not expose the tank to the sun directly.

Note:

• Remove the pad from the mopping module before cleaning it, and make sure 

  dirty water does not flow back into the water outlet to avoid clogging.
• For optimal performance, it is recommended to replace the mop pad every 3-6 

  months.