Kuppersberg GS 4505 - Инструкция по эксплуатации - Страница 4

4

Technical passporT

english

dishwasher

In the event of problems, contact the dealer or 

your nearest After sales Service.

The appliance must be disconnected from 

the power supply before any installation 

operation.

During installation, make sure the appliance 

does not damage the power cable.

Only activate the appliance when the 

installation has been completed.

Connection to the mains water supply must 

be  carried  out  by  a  qualified  technician  in 

compliance with the manufacturers instructions 

and applicable local safety regulations.

The appliance is to be connected to the 

water mains using new hose sets. The old 

hose-sets should not be reused. All hoses must 

be securely clamped to prevent them coming 

loose during operation. All local waterboard 

regulations must be complied with. Water 

supply pressure 0.05 - 1.0 MPa.

The inlet water temperature depends on the 

dishwasher model. If the installed inlet hose 

is marked «25°C max», the maximum allowed 

water temperature is 25°C. For all other models 

the maximum allowed water temperature is 

60°C.

Do not cut hoses and, in the case of 

appliances  fitted  with  a  waterstop  system,  do 

not immerse the plastic casing containing the 

inlet hose in water.

If hoses are not long enough, contact your 

local dealer.

Make sure the inlet and drain hoses are 

kink-free and are not crushed. Before using the 

appliance  for  the  first  time,  check  the  water 

inlet and drain hose for leaks.

During use, the access to the rear wall 

should be limited in a sustainable manner 

such as approaching the device to the wall or 

furniture board.

When installing the appliance make sure 

that the four feet are stable and resting on the 

floor,  adjusting  them  as  required,  and  check 

that the appliance is perfectly levelled using 

a spirit level.

If installing the appliance at the end of a 

row of units making the side panel accessible, 

the hinge area must be covered to prevent risk 

of crushing.

For dishwashers having ventilation 

openings in the base, the openings must not 

be obstructed by a carpet.

E L E CT R I CA L  WA R N I N G S

For installation to comply with current 

safety regulations, an omnipolar switch with 

minimum contact gap of 3mm

is required and the appliance must be 

earthed.

If the power cable is damaged, replace 

with an identical one. The power cable must 

only  be  replaced  by  a  qualified  technician  in 

compliance with the manufacturer instruction 

and current safety regulations. Contact an 

authorized  service  centre.  If  the  fitted  plug  is 

not suitable for your socket outlet, contact a 

qualified technician. The power cable must be 

long enough to connect the appliance, once 

fitted in its housing, to the main power supply. 

Do not pull the power supply cable.

Do not use extension leads, multiple sockets 

or adapters.

Do not operate this appliance if it has a 

damaged mains cord or plug, if it is not working 

properly, or if it has been damaged or dropped. 

Keep the cord away from hot surfaces. The 

electrical components must not be accessible 

to the user after installation. Do not touch the 

appliance with any wet part of the body and do 

not operate it when barefoot.

CO R R E CT  U S E

The water in the dishwasher is not potable.

The maximum number of place settings is 

shown in the product sheet.

The door should not be left in the open 

position since this could present a tripping 

hazard. The open dishwasher door can only