Electrolux EKM 70150 X - Инструкция по эксплуатации - Страница 52

Adaptation to different kinds of gas

To adapt the appliance to a different kind of
gas from the one the appliance has been set
for, follow the instructions below in their or-
der.
Gas connection :

LPG

: use the rubber pipe holder «D».

Natural gas

 : use the pipe holder «E».

Always insert the gasket sealing «B». Then
proceed with the gas connection, as indica-
ted in the relevant paragraphs.

Hob burners nozzles
Nozzles replacement

1. Remove the pan supports.
2. Extract the caps and the wall baffles of

the burners.

3. Using a socket spanner 7 unscrew and

remove the nozzles replacing them with
the ones required for the kind of gas in
use (see table " Burner characteristics " ) .

1

Gas connection point

2

Gasket

3

Adjustable connection

4

LPG rubber pipe holder

5

Natural gas pipe holder

4. Reassemble the parts following the same

procedure backwards.

5. Replace the rating label (placed near the

gas supply pipe) with the relevant one for
the new type of gas supply. You can find
this label in the package of the injectors
supplied with the appliance.

These burners do not need any primary air
regulation.

Adjustment of minimum level

To adjust the minimum level of the burners,
proceed as follows:
1. light the burner;
2. turn the knob on the position of minimum

flame;

3. remove the knob;
4. with a thin screwdriver, adjust the by-

pass screw;

If changing from natural gas 20 mbar/13
mbar to liquid gas, completely tighten
the adjustment screw in, until a small
regular flame is obtained.

If changing from liquid gas to natural gas
20 mbar, undo the by-pass screw about
1/4 of a turn, until a small regular flame
is obtained.

If changing from natural gas 20 mbar to
natural gas 13 mbar undo the by-pass
screw about 1/4 of a turn, until a small
regular flame is obtained.

If changing from liquid gas to natural gas
13 mbar, undo the by-pass screw about
3/4 of a turn, until a small regular flame
is obtained.

Reassemble the parts following the same
procedure backwards.
Finally, check the flame does not go out
when quickly turning the knob from the max-
imum position to the minimum position.

Electrical connection

The unit is preset to work with a voltage of
single phase 230 V.
Before making the connection make sure
that:
• the energy power available in the user's

house is sufficient for the normal supply of
this appliance (see rating plate)

• the unit is correctly connected to earth

through a suitable plug and according to
the installation country Laws

52 

 electrolux