Плита Electrolux EKM 70150 X - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Important!
Our responsibility will not be
involved in case of accidents caused by a
defective or non existent earth connection.
Combustion products discharge
Gas cooking units must discharge combus-
tion products through hoods directly con-
nected to flues or outside.
Connection using a rigid pipe or a
flexible metal pipe
To ensure higher safety, it is recommended
to carry out the connection to the gas system
using rigid pipes (ex. copper) or using flexible
stainless steel pipes, to avoid any stress to
the unit. Gas feeding pipe fitting is Gc 1/2.
For this type of installation, connection to the
gas supply should be carried out using only
and exclusively flexible metallic tubes in con-
formity with rules in force.
Connection using flexible non metal
pipes
When the connection can be easily inspec-
ted in its full extent, there is the chance to use
a flexible pipe according to the rules in force.
The flexible pipe must be tightly fixed using
clamps according to the rules in force.
The flexible pipe should be made ready for
use in such a way that:
• nowhere it can reach over temperature,
other than room temperature, higher than
30
°
C; if the flexible pipe, to reach the cock,
must run behind the range, it must be in-
stalled as shown below;
• it is no longer than 1500 mm;
• it shows no throttles;
• it is not subject to traction or torsion;
• it does not get in touch with cutting edges
or corners;
• it can be easily inspected in order to check
its condition.
The control of preservation of the flexible pipe
consists in checking that:
• it doesn't show cracks, cuts, marks of
burning both on the end parts and on its
full extent;
• the material is not hardened, but shows its
normal elasticity;
• the fastening clamps are not rusted;
• expiry term is not due. If one or more ab-
normalities are seen, do not repair the
pipe, but replace it.
Important!
Once installation is complete,
check the perfect seal of every pipe fitting,
using a soapy solution, never a flame.
electrolux
51
