STATUS CP190C - Инструкция по эксплуатации - Страница 7

7

Additional safety instructions for all saws with riving knife

• 

Use the appropriate saw blade for the riving knife. 

For the riving knife to function, the 

body of the blade must be thinner than the riving knife and the cutting width of the blade 

must be wider than the thickness of the riving knife.

• 

Adjust the riving knife as described in this instruction manual.  

Incorrect spacing, 

positioning and alignment can make the riving knife ineffective in preventing kickback.

• 

Always use the riving knife except when plunge cutting.

 Riving knife must be replaced 

after plunge cutting. Riving knife causes interference. 

• 

For the riving knife to work, it must be engaged in the workpiece. 

The riving knife is 

ineffective in preventing kickback during short cuts.

• 

Do not operate the saw if riving knife is bent. 

Even a light interference can slow the 

closing rate of a guard.

• 

Wear hearing protection during continuous operation. 

Exposure to noise can cause 

hearing loss.

• 

During operation provide eye protection to prevent eyes from  exposure to flying 

particles.

 Wear goggles.

• 

Take protective measures against inhalation of dust. Some materials can contain 

toxic ingredients.  

Wear a dust mask and work with dust/chip extraction when 

connectable.

• 

Do not process materials containing asbestos. 

Asbestos is considered carcinogenic.

• 

Use of protective gloves is recommended.

• 

Before connecting a tool to a power source be sure that the voltage supply is the 

same as that specified on the nameplate of the tool. 

• 

A power source with a voltage greater than that specified for the tool can result in 

serious injury to the user, as well as damage to the tool. 

If in doubt, do not plug in the 

tool. Using a power source with a voltage less than the nameplate rating is harmful to the 

motor.

• 

Fully unwind cable drum extensions to avoid potential overheating.

• 

When an extension cable is required, you must ensure that it has the right ampere 

rating for your power tool and it is in safe electrical condition.

• 

Never use the machine with a damaged cable. Do not touch the damaged cable and 

pull the mains plug when the cable is damaged while operating. 

Damaged cables 

increase the risk of electric shock.

• 

Always keep the cord away from the working area of the power tool.

• 

Prior to operation remove all nails, screws and other objects from the work piece. 

You may damage the saw blade and the machine by cutting into a nail or other 

metal. It can also present a safety hazard.

• 

Use clamps or a vice to secure your work whenever possible.

• 

Never start the power tool under load. Make sure that the saw blade is not in 

contact with the work piece when you switch the machine on.

• 

Always switch off and wait until the saw blade has come to a complete standstill 

before removing the machine from the work piece.

CIRCULAR SAW SAFETY RULES

EN