STATUS CP190C - Инструкция по эксплуатации - Страница 6

6

EN

• 

Maintain a firm grip with both hands on the saw and position your arms to resist 

kickback forces. Position your body to either side of the blade, but not in line with 

the blade.  

Kickback could cause the saw to jump backwards, but kickback forces can be 

controlled by the operator, if proper precautions are taken.

• 

When blade is binding, or when interrupting a cut for any reason, release the trigger 

and hold the saw motionless in the material until the blade comes to a complete 

stop. Never attempt to remove the saw from the work or pull the saw backward 

while the blade is in motion or kickback may occur. 

Investigate and take corrective 

actions to eliminate the cause of blade binding.

• 

When restarting a saw in the workpiece, centre the saw blade in the kerf and check 

that saw teeth are not engaged into the material. 

If saw blade is binding, it may walk 

up or kickback from the workpiece as the saw is restarted.

• 

Support large panels to minimise the risk of blade pinching and kickback. 

Large 

panels tend to sag under their own weight. Supports must be placed under the panel on 

both sides, near the line of cut and near the edge of the panel.

• 

Do not use dull or damaged blades. 

Unsharpened or improperly set blades produce 

narrow kerf causing excessive friction, blade binding and kickback.

• 

Blade depth and bevel adjusting locking levers must be tight and secure before 

making cut. 

If blade adjustment shifts while cutting, it may cause binding and kickback.

• 

Use extra caution when sawing into existing walls or other blind areas.

 The 

protruding blade may cut objects that can cause kickback.

Safety instructions for circular saws with outer pendulum guard, circular saws with 

inner pendulum guard , circular saws with tow guard

• 

Check lower guard for proper closing before each use. Do not operate the saw if 

lower guard does not move freely and close instantly. Never clamp or tie the lower 

guard into the open position. 

 If saw is accidentally dropped, lower guard may be bent. 

Raise the lower guard with the retracting handle and make sure it moves freely and does 

not touch the blade or any other part, in all angles and depths of cut.

• 

Check the operation of the lower guard spring. If the guard and the spring are not 

operating properly, they must be serviced before use.

 Lower guard may operate 

sluggishly due to damaged parts, gummy deposits, or a build-up of debris.

• 

Lower guard may be retracted manually only for special cuts such as “plunge cuts” 

and “compound cuts”. Raise lower guard by re-tracting handle and as soon as blade 

enters the material, the lower guard must be released.

 For all other sawing, the lower 

guard should operate automatically.

• 

Always observe that the lower guard is covering the blade before placing saw down 

on bench or floor. 

 An unprotected, coasting blade will cause the saw to walk backwards, 

cutting what-ever is in its path. Be aware of the time it takes for the blade to stop after 

switch is released.

CIRCULAR SAW SAFETY RULES