STATUS CP190C - Инструкция по эксплуатации - Страница 11

11

OPERATION

SWITCHING ON/OFF
WARNING:

  When starting the circular saw, hold it securely with both hands. The torque 

from the motor can cause the tool to twist.

Switching on:

 Press the lock-off button (22), and then squeeze the ON/OFF switch (9).

Switching off:

 Release the ON/OFF switch (9).

Your saw should be running at full speed before starting the cut and turned off only after 

completing the cut.

DUST EXTRACTION

Use a vacuum cleaner during operation. Connect the vacuum cleaner to the dust extraction 

port (7) and switch on the vacuum cleaner prior to starting a cut.

CUTTING

Always hold the back handle (8) with one hand and the front handle (11) with the other 

hand. 

WARNING: 

 After switching off the saw, be aware of the necessary time it takes for the 

blade to come to a complete stop during coast down. Do not allow the saw to brush 

against your body, since the blade guard (20) is retractable, it could catch on your clothing 

and expose the blade (1).
When cutting is interrupted, to resume cutting, depress the lock-off button (22), squeeze 

the ON/OFF switch (9) and allow the blade (1) to reach full speed, re-enter the cut slowly 

and resume cutting.

When cutting across the grain, the fibres of the wood have a tendency to tear and lift. 

Advancing the saw slowly minimizes this effect.

Cutting Large Sheets

Large sheets and long boards sag or bend, depending on support. If you attempt to cut 

without levelling and properly supporting the piece, the blade will tend to bind, causing 

kickback and extra load on the motor.

Use timber underneath the sheet or board to raise it for support. This will ensure a safe and 

stable cutting operation. Support the panel or board close to the cut. Be sure to set the 

depth of the cut so that you cut through the sheet or board only and not the table or work 

bench. If the sheet or board to be cut is too large for a table or work bench, use supporting 

timbers on the floor and secure.

Rip cuts

The rip fence (15) is used when cutting parallel to the edge of a shaped part. To attach rip 

fence (15), insert rip fence through rip fence slots in base plate (5) to desired width and 

secure with the rip fence lock knob (17).

EN