Ballu-Biemmedue FIRE 25 - Инструкция по эксплуатации - Страница 13

EN

13 

heater. 

Connection to the heater is made by removing the socket cover 

(15) and inserting the thermostat plug. 

To start the machine you must: 
• if connected to the thermostat, turn the switch to (ON +  ); 
• if not connected to the thermostat, turn the switch to (ON); 
 

Warning 

At the end of the start cycle, the electronic control 
device causes button (13) to flash briefly to confirm 
completion of the heater start cycle. 

When unit is started for the first time or is started after the oil tank 

has been totally emptied, the diesel flow to the burner may be 
impaired by air in the circuit. In this case the control box will cut out 
the heater and it might be necessary to renew the starting procedure 
once by depressing the reset button (13). 

If the heater does not function, the first things to do are: 
1. Check that the tank still contains some diesel; 
2. Push reset button (13); 
3. If the heater still does not function, see TROUBLESHOOTING” 

to identify the cause of the malfunction. 

Warning 

Never stop the machine by unplugging the electrical 
plug: this could cause overheating. 

 
STOPPING THE HEATER 

Set main switch (14) on “0” position or turn thermostat or other 

control device on lowest setting. 

The flame goes out and the fan continues to work for 

approximately 90 sec. cooling the combustion chamber. 
 
 

TRANSPORT

Warning 

Before moving the heater: 
• Stop the heater as indicated in the “STOP” 

paragraph; 

•  Cut electrical power by removing the plug from the 

electrical socket; 

•  Wait until the heater cools. 

 
Before moving the heater, make sure the oil tank cap is securely 

attached. 

Warning 

Diesel may leak during handling and transport: the fuel 
tank cap is not sealed. This allows air to enter and 
allows the tank to be emptied while the heater is 
running. 
 

For handling in short to medium distances, it is enough to grab the 
generator by the handle and roll it on its wheels. 

 
MAINTENANCE 

To ensure correct heater function, you have to clean the 

combustion chamber, burner, and fan at regular intervals. 

 
Warning 

Before starting any maintenance procedure, ALWAYS: 
• Stop the heater as indicated in the “STOP” 

paragraph; 

•  Cut electrical power by removing the plug from the 

electrical socket; 

•  Wait until the heater cools. 

 
Every 50 hours of operation:  
•  Disassemble the filter cartridge, remove it, and clean it with 

clean diesel fuel; 

•  Disassemble the external cylindrical fairing and clean the inside 

and the fan blades; 

•  Check the condition of the leads and of the high-voltage 

connections to the electrodes; 

•  Disassemble the burner and clean all of its parts. Clean the 

electrodes and set the gap to the value specified in the 
paragraph “SETTING THE ELECTRODES”.