Ardesto DMC-SA1212SB - Инструкция по эксплуатации - Страница 32

EN

32

DEVICE OPERATION

Turning off beeps

You can activate/deactivate the beeps in any mode of operation of the device, except 

for the program setting before the start�

To do this, in any mode other than the program setting mode, press and hold the “

–

“  

button, the indicator for switching off the beeps will light up�

To turn on the buzzers, press and hold the “

–

“  button again will beep, the indicator for 

switching off the buzzers will turn off�

Locking the Control Panel

 Do not turn on the appliance without a bowl installed or with an empty bowl - if you 

accidentally start a cooking program, it will critically overheat the appliance or damage 

the nonstick coating�

 For added safety, the appliance has a control panel lock feature that prevents 

accidental button presses�

To lock the control panel in any mode, except the program setting before the start, 

press and hold the “

+

“  button, the appliance will beep and the control panel lock 

indicator will light up� If you press any button, the control panel lock indicator will flash� 

To release the lock, press and hold the “

+

“  button again, the unit will beep and the 

control panel lock indicator light will turn off�

General procedure when using automatic cooking programs

IMPORTANT: When using the appliance to boil water (for example for boiling foods) DO 

NOT use temperatures higher than 100°C. This may cause overheating and damage to 

the appliance. For the same reason, DO NOT use the «PILAF», «BAKE», «BREAD» or «FRY» 

programs to boil water.

1�  Prepare (measure out) the necessary ingredients�

2�  Place the ingredients in one of the bowls of the multicooker, following the 

instructions of the recipe book or the Summary table of cooking programs (if you 

cook according to your recipe)� It is possible to use both bowls at the same time� 

Make sure that all ingredients, including liquid, are below the maximum mark on 

the inside of the bowl� Make sure that the bowl is positioned correctly and that it is 

in contact with the heating element�

3�  Close the lid of the used bowl of the multicooker until you hear a click� Connect the 

power cord to the connector on the device�

WARNING: If you cook at high temperatures using a lot of vegetable oil, always leave 

the lid open.

4�  Connect the device to the mains, the sound signal will be heard, all indicators will 

light up for a few seconds� Then the device will go into standby mode (the display 

will show - - - - - -)�

5�  5� Press the “l or ll”  button to activate the menu for one of the bowls� The indicators 

of the “CANCEL”  button of the selected bowl and the “START” button light up, the 

indicator light of the button will flash�

6�  Using  the “

+

/

–

“ buttons, select the required cooking program, the indicator of the 

selected program will flash� The programs are rotated and the display will show the 

default cooking time (except for the «RICE» program)�