Royal Sovereign ES 915 - Инструкция по эксплуатации - Страница 4

4

OPERATION

Hot Lamination

1. Place the machine on a flat, sturdy surface and press the power button to turn on the machine.
2. Pull out the cooling guides.
3.  The machine is preset to the 75 mic setting.  To change the setting press the setting control button.  The machine will take 

approximately 4 minutes to warm-up.  When the proper temperature is reached, the ready light will glow steady.

NOTE

:  Standard temperature setting is based on 20lb. / 80g/m

2

 copy paper thickness. When laminating thicker materials, the 

temperature may not be high enough. In this case, please set on higher temperature (up 1 level) before laminating. 
4. Place the item to be laminated into the laminating pouch.
5. Insert the pouch film into the front opening of the laminator.  Make sure to place the sealed end of the pouch film in first.
6. The document or photo will then automatically feed out the through the back of the machine.

NOTE

:  Laminated items exiting the machine may be too hot to touch.

7. If the item is not completely laminated, repeat steps 4-5.

NOTE

:  Laminated items will be hot and will easily bend. To keep the item flat, place on a flat surface and allow it to cool

or lay item on the cooling guides.

Before laminating important or unique documents, 

always test a pouch through the laminator using a similar document.

Cold Lamination

1. Place the machine on a flat, sturdy surface and press the power button to turn on the machine.
2.  Press the setting control button until the Cold lamination setting is lit.  If  the machine was previously used in hot mode, 

allow approximately 25 minutes to cool down.  When the proper temperature is reached, the ready light will glow 

steady.

3.  Place the document to be laminated on the adhesive side of  the cold film with the document face down, sealed end 

first.

4. Inser t the document to be laminated into the front opening of  the machine.
5. Remove paper liner from the cold film slowly while the document is being inser ted into the machine.