Tesla TT27TP61S - Инструкция по эксплуатации - Страница 44

44

ENG

Emergency button:

Open the panel and find the emergency button on the electronic control box when the remote controller fails . 
(Always press the emergency button with insulation material.)

Current status

Operation

Respond

Enter mode

Standby

Press the emergency button once

It beeps briefly once.

Cooling mode

Standby (Only for 

heating pump)

Press the emergency button twice 
in 3 seconds

It beeps briefly twice.

Heating mode

Running

Press the emergency button once

It keeps beeping for a 
while

Off mode

control-box cover

(open the panel of indoor unit)

ON/OFF

INSTRUCTION FOR SERVICING (R32)

1.   Check the information in this manual to find out the dimensions of space needed for proper installation of the 

device, including the minimum distances allowed compared to adjacent structures.

2.   Appliance shall be installed, operated and stored in a room with a floor area larger than 4m

2

. 

3.  The installation of pipe-work shall be kept to a minimum.
4.   The pipe-work shall be protected from physical damage, and shall not be installed in an unventilated space if 

the space is smaller than 4m

2

  .

5.  The compliance with national gas regulations shall be observed.
6.  The mechanical connections shall be accessible for maintenance purposes.
7.   Follow the instructions given in this manual for handling, installing, cleaning, maintaining and disposing of the 

refrigerant.

8.   Make sure ventilation openings clear of obstruction.
9. 

 Notice

:The servicing shall be performed only as recommended by the manufacturer.

10.   

Warning

: The appliance shall be stored in a well-ventilated area where the room size corresponds to the room 

area as specified for operation.

11.   

Warning

:The appliance shall be stored in a room without continuously operating open flames (for example 

an operating gas appliance) and ignition sources (for example an operating electric heater).

12.   The appliance shall be stored so as to prevent mechanical damage from occurring.
13.   It is appropriate that anyone who is called upon to work on a refrigerant circuit should hold a valid and up-to-

date certificate from an assessment authority accredited by the industry and recognizing their competence 

to handle refrigerants, in accordance with the assessment specification recognized in the industrial sector 

concerned. Service operations should only be carried out in accordance with the recommendations of the 

equipment manufacturer. Maintenance and repair operations that require the assistance of other qualified 

persons must be conducted under the supervision of the person competent for the use of flammable 

refrigerants.

14.   Every working procedure that affects safety means shall only be carried out by competent persons.