STANLEY FatMax DST 10186 100552280 - Инструкция по эксплуатации - Страница 20

G

B

20

any  part  of  the  casing  unless  qualified  to  do  so;  this  unit 

contains dangerous voltages.

  Warning!  

For your protection if this product is to be used outdoors it 

should not be exposed to rain or used in damp locations. Do 

not place the product on damp surfaces, use a workbench 

if  available.  For  added  protection  use  a  suitable  residual 

current device (R.C.D.) at the socket outlet.

Note:

  If  the  mains  cable  requires  replacing  it  must  be 

replaced with an identical one and fitted by a qualified 

person.

5.4 

I/O switch (On/Off) (ref. 8)

To switch on the equipment set the On/Off switch (ref. 8) 

to position 

I

.

Move the On/Off switch (ref. 8) to position 

O

 to switch off 

the equipment.

  Warning!  

After  switching  off  the  compressor,  you  must  wait 

three seconds before switching on the machine again.

5.5  Adjusting the pressure

● You can adjust the pressure on the pressure gauge (ref. 

6) using the pressure regulator (ref. 7).

● The  set  pressure  can  be  taken  from  the  quicklock 

coupling (ref. 5).

5.6  Setting the pressure switch

The pressure switch is set at the factory.

● When the upper calibration value (set by the manufacturer) 

has been reached, the compressor stops.

  When air is used, the compressor restarts automatically 

when the lower calibration value is reached.

●

The compressor continues to operate according to this 

automatic cycle until the 

I/O

 switch is turned.

6. 

CLEANING AND MAINTENANCE

  Warning!  

Pull  the  power  plug  before  doing  any  cleaning  and 

maintenance work on the appliance.

  Warning!  

Wait  until  the  compressor  has  completely  cooled 

down. Risk of burns!

  Warning!  

Always depressurize the tank before carrying out any 

cleaning and maintenance work.

6.1  Cleaning

●

Keep the safety devices free of dirt and dust as far as 

possible. Wipe the equipment with a clean cloth or blow 

it with compressed air at low pressure.

●

We recommend that you clean the appliance immediately 

after you use it.

● Do not use cleaning agents or solvents; these may be 

aggressive to the plastic parts in the appliance. Ensure 

that no water can get into the interior of the appliance.

●

You must disconnect the hose and any pneumatic tools 

from the compressor before cleaning. Do not clean the 

compressor with water, solvents or the like.

6.2 

Condensation water (Fig. 4)

The condensation water must be drained off each day 

by opening the drain valve (ref. 11) (on the bottom of the 

pressure vessel).

  Warning!  

Dispose  of  the  condensation  water  in  an 

environmentally compatible manner at the appropriate 

collection point.

6.3  Safety valve (ref. 10)

The safety valve has been set for the highest permitted 

pressure  of  the  pressure  vessel.  It  is  prohibited  to  adjust 

the  safety  valve.  Actuate  the  safety  valve  from  time  to 

time  to  ensure  that  it  works  when  required.  Pull  the  ring 

with sufficient force until you can hear the compressed air 

being released (Fig. 6). Then release the ring again.

MAINTENANCE RESUMPTIVE TABLE

FUNCTION

AFTER THE FIRST 

100 HOURS

EVERY 100 HOURS

Cleaning of intake filter and/or 

substitution of filtering element

●

●

Draining tank condensate

Daily and at the end of work