Ardesto YCM-E1600 - Инструкция по эксплуатации - Страница 33

33

FROTHING MILK/ MAKE CAPPUCCINO

You get a cup of cappuccino when you top up a cup of espresso 

with frothing milk. Method:

1.  

Prepare espresso first with container big enough according to the 

part “MAKE ESPRESSO COFFEE”, make sure that the steam control 

knob is at the “OFF” or “0” position.

2.  

Press the steam switch to the “1” position, waiting for until the 

green indicator is illuminated.

NOTE: 

During operation, if the green indicator is extinguished, you 

should turn the steam control knob to “OFF”or “0” position. Press 

coffee/hot water selector to the “1” position and pump water, after 

about 30s, close the pump (coffee/hot water selector to the “0” 

position), then wait for until the green indicator is illuminated and 

turn the steam control knob in anti-clockwise, the steam will come 

out again.

3.  

Fill a jug with about 100 grams of milk for each cappuccino to be 

prepared, you are recommended to use whole milk at refrigerator 

temperature (not hot!).

NOTE: 

In choosing the size of jug, it is recommend the diameter is 

not less than 70±5mm, and bear in mind that the milk increases in 

volume by 2 times, make sure the height of jug is enough.

4.  

Turn the steam control knob slowly in anti-clockwise, steam will 

come out from the frothing device.

NOTE: 

Never turn the steam control button rapidly, as the steam will 

accumulate rapidly in short time which may increase the potential 

of the risk of explosion.

5.  

Insert the frothing device into the milk about two centimetre, 

froth milk in the way moving vessel round from up to down.

6.  

When the required purpose is reached, you can turn the steam 

control knob to “OFF” or “0” position.

NOTE: 

Clean steam outlet with wet sponge immediately after steam 

stops generating, but care not to hurt!

EN