Кофеварка BRAYER BR1103 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
9
EN
using the flask (14). Install the lid (9) back to its place
and thread it rotating clockwise.
• Place a cup with cold milk or cream under the tip
(11).
•
Switch the coffee maker on by setting the operation
mode switch (7) to the position «
steam
», the indicator (8)
will light up, the heating element will switch on and
the steam under pressure will be released from the
tip (11).
• Put the tip (11) into the cup with cold milk or cream.
•
The tip (11) should not touch the bottom of the cup,
as this can prevent the steam release.
•
The outgoing steam creates whirls which froth milk;
from time to time lift and lower the cup with milk or
cream against the tip (11) to make the milk foam.
Note:
always put the tip (11) for approximately 1-2 cm
into milk or cream.
•
If you cannot make frothed milk, don’t worry and
experiment until you achieve good results. Try
making frothed milk with the removed tip (11).
• Set the operation mode switch (7) to the position «
» to switch the coffee maker off and to release the
pressure.
•
Add frothed milk to the ready espresso, add sugar to
taste. You can decorate the frothed milk with cocoa
powder.
•
After frothing the milk clean the cappuccinator pipe
(10) and wash the tip (11).
•
Remove the tip (11), wash it under a warm water jet,
then dry it.
• Immerse the cappuccinator pipe (10) into a container
with water, switch the steam supply on by setting the
operation mode switch (7) to the position «
steam
». In
10-15 seconds set the operation mode switch (7) to
the position «
» to switch the coffee maker off.
DESCALING
•
For effective operation of the coffee maker it is
necessary to clean (descale) the coffee maker from
mineral deposits every 2-3 months.
Note:
to remove the scale you can use special
descaling agents for coffee makers and coffee
machines, strictly following the instructions on their
usage.
1. Make sure that the power plug is not inserted into
the mains socket, and the operation mode switch
(7) is set to the position «
».
2. Remove the water tank lid (9) turning it
counterclockwise and pour the descaling agent into
the water tank, using the flask (14). Do not exceed
the maximal capacity of the water tank.
3. Install the lid (9) back to its place and thread it
rotating clockwise.
4.
Put the filter (6) into the holder (5), do not add
ground coffee into the filter (6).
