Smeg BCC02WHMEU - Инструкция по эксплуатации - Страница 27

EN - 10

If the LED (25) 

 flashes, it means that a 

descaling cycle is mandatory to proceed with 

further dispensing of drinks. 

To carry out a descaling cycle, proceed as 

follows:

•  Place a container with a capacity of at least 

1.4l under the dispenser (11) and the steam 

spout (30).

•  Make sure that the 

Primary

 program with 

white illuminated keys is selected.

•  Fill the tank (5), up to the “MAX” level, with a 

solution of water and descaler in the doses 

recommended by the manufacturer.

•  With the machine ready for use, press 

the keys (20) 

 and (18) 

simultaneously for at least 3 seconds. The 
key (18) 

 flashes with an orange light 

and the LED (25) 

 has a fixed light for 

the entire duration of the descaling cycle, 

which has duration of several minutes.

•  The descaling cycle ends when the solution 

contained in the tank (5) is finished, the key 
(18) 

 and the LEDs (21) 

 and 

(25) 

 light up fixed.

•  During the descaling cycle, the machine will 

take a few breaks to allow the descaler to 

act effectively. Wait for the end of the cycle.

•  Pour clean water into the tank (5) up to the 

“MAX” level to carry out the rinse cycle, then 
press the button (18) 

 to start the rinse 

cycle, the button (18) 

 flashes and the 

LED (25) 

 lights up steadily for the entire 

duration of the washing cycle.

•  When the tank (5) is empty, the rinse cycle 

is finished.

•  The keys light up in white.

 If, at the end of the descaling 

process, the LED (25) 

 remains 

permanently lit, it indicates that 

a new descaling cycle must be 

carried out since the quantity 

of descaling solution that was 

used was insufficient for complete 

cleaning.

 Any other ser vicing should be 

p e r f o r m e d   b y   a n   a u t h o r i z e d 

service representative.

“Empty system” procedure

The ‘Empty system’ procedure is recommended 

before long periods of non-use and before 

consulting a maintenance manager.

•  Activate the procedure by holding down 

the key (16) 

 and the key (19) 

simultaneously for three seconds, the key 
(17) 

 and the key (19) 

 flash 

simultaneously.

•  The entire quantity of water in the tank is 

drained through the coffee circuit and the 

steam spout.

•  The pump continues to operate, even 

intermittently, to also empty the internal 

water circuits.

•  At the end of the procedure the machine 

switches off.

 The empty system procedure takes 

several minutes and on-off cycles. 

Do not turn off the machine until the 

complete procedure is complete. 

Cleaning and maintenance