Smeg BCC02WHMEU - Инструкция по эксплуатации - Страница 26

EN - 9

EN

Cleaning and maintenance

Cleaning the external drip tray (14)

The drip tray (14) is equipped with a red 

float (27) which protrudes from the cup-holder 

grid as soon as the maximum liquid level is 

exceeded.

•  Remove the tray (14) and the cup-holder 

grid (28) and empty it.

•  Clean the tray (14) and the grid (28) in 

running water with neutral dish detergent.

•  Dry the components and reassemble them 

in the machine.

C l e a n i n g   t h e   c o f f e e   g r o u n d s 

container (12) and internal tray (13)

Always empty the coffee grounds 

container with the appliance 

switched on. This is the only way 

of resetting the coffee grounds 

counter.

•  Remove the tray (14).

•  Remove the grounds container (12) with its 

tray (13) by pulling it outwards.

•  Empty the coffee grounds from the container 

(12).

•  Clean the container (12) and the tray (13) 

in running water with neutral dish detergent.

•  Dry the components and reassemble them 

in the machine.

Daily cleaning of the coffee grounds 

container and inter nal tray is 

recommended.

Cleaning the water tank (5)

•  Remove the lid (4) and remove the tank (5) 

from the machine using the appropriate 

handle.

•  Clean the tank (5) in running water with 

neutral dish detergent and reassemble it in 

the machine.

Cleaning the brewing group (15)

Before performing this cleaning 

operation, ALWAYS disconnect the 

plug from the power outlet.

•  Press the door (8) in the lower part until it 

releases then remove it from the upper part.

•  Press the two release clips (29) located on 

the sides of the infuser (15) and remove it 

from the machine

 (Fig.L).

•  Wash the brew group (15) with running 

water, dr y it and reassemble it in the 

machine, making sure it is positioned 

correctly.

•  Refit the service door (8) making sure it is 

correctly positioned.

 Do not wash the brewing group 

in the dishwasher in order not to 

damage it permanently.

Steam wand cleaning (30)

•  Wait for the steam wand (30) to cool before 

operating.

•  Remove the lower part (34) of the steam 

wand by turning it anticlockwise to release 

it then pull it downwards.

•  Clean with running water and reassemble 

everything in the reverse order.

Descaling

The cof fee machine signals when it is 

necessary to carry out a descaling cycle based 

on the set water hardness (For the setting of the 

water hardness, see the “Machine Settings” 

paragraph). 
If the LED (25) 

 lights up steadily, it means 

that a descaling cycle is necessary, so as not 

to alter the taste of the coffee and damage the 

machine. However, coffee and further drinks 

may continue to be dispensed for a limited 

number of cycles.