Legrand 2200 - Инструкция по эксплуатации - Страница 35

35

KEOR LINE  RT  1000, 1500, 2200, 3000 VA 

EN

Plug-in Charge

1.   If the Input Power Cord is connected to the wall receptacle properly and the utility is normal, 

the UPS will start charging automatically without processing the “Turn On” procedure.

2.   You have to charge for at least 8 hours every 3 months to avoid from battery self over-discharge 

naturally, if the UPS is in an idle condition.

 IMPORTANT NOTICE

Plug the UPS onto the wall receptacle to charge the UPS for over 8 hours after initial 

installation.

 STORAGE

Store at -15 to +30 °C (+5 to +86 °F), charge the UPS battery every six months.

Store at +30 to +45 °C (+86 to +113 °F), charge the UPS battery every three months

Auto-Restart

When the AC power fails the UPS continues to operate in battery mode and shutdown if the power 

outage lasts longer than the battery backup time . The UPS automatically restarts to supply the 

loads when the power is restored.

 Alarm Silence

1.   The Alarm might be turned off by pressing the “On” button for approximately 1 second when 

the UPS is working in backup mode.

2.   Once the “Alarm Silence” is turned off  the alarm remains in Silence condition Unless any other 

warning or fault condition occurs.

 Self Test

1.   Under Utility Normal condition, press the “On” button for 3 seconds to execute the Battery self-

test function.

2.  In case the battery is normal, the UPS enters in  Battery Backup Mode for 10 seconds then 

returns to Utility Mode.

3.   If the battery voltage is detected lower than the threshold limit, the Battery Replacement led  

blinks for 5 seconds. If the  battery is detected weak or dead, the Battery Replacement led 

steadily lights.

 CAUTION

The UPS doesn’t supply the loads connected to its outputs  if the start up operation is not 

executed properly, even if the input power cord is connected to the wall receptacle.