Liebherr CBesf 4006 BioFresh - Инструкция по эксплуатации - Страница 8

18

Cleaning

W

Before cleaning, always switch off the appliance. Dis-

connect from the mains or un screw or remove the 

fuse.

W

  Clean the inside and equipment by hand with lukewarm 

water and a little detergent.  

Because of the risk of injury and damage to the appli-

ance, steam cleaning equipment should not be used.

W

  Clean the side panels and door surfaces with a clean and 

soft cloth. If necessary, use a moist cloth (water + deter-

gent). Alternatively, use a micro-fibre cloth.

-  Do not use scouring/abrasive sponges, concentrated 

cleaning agents and cleaning or chemical solutions con-

taining sand, chloride or acids; they damage the surfaces 

and can cause corrosion. 

W

  Do not allow cleaning water to run down the drain gulley or 

to penetrate the ventilation grilles or electrical components. 

Dry the appliance.

-  Do not damage or remove the type plate on the inside of 

the appliance - it is important for the customer service de-

partment.

W

  To clean the 

BioFresh draw-

ers, 

pull the drawers right 

out, grip at back and lift out, 

fig. 

M1

.

-  To re-insert: place the draw-

ers on the extended rails - the 

rails must be aligned with the 

front of the drawer - and slide 

in, fig. 

M2

. 

W

  The dust should be removed 

from the

 refrigeration unit 

and heat exchanger - metal 

grid at the back of the ap-

pliance - once a year. Dust 

deposits increase energy 

consumption.

W

  Ensure that none of the wires or other components are 

dislodged, bent or damaged.

If the appliance is to be

 left switched off for any length of 

time

, empty the appliance, disconnect from the mains, clean 

as described above and  leave the door open so as to avoid 

odours.

*

 Depending on model and options 

Defrosting

The refrigerator and BioFresh compartment 

defrost automatically. The defrost water is evaporated by the 

heat from the compressor.

The freezer compartment

after the appliance has been in operation for some time, 

a layer of ice will form if the door is opened and fresh food 

placed inside the freezer regularly. This is completely normal. 

However, a thick layer of ice will increase the appliance’s en-

ergy consumption. You should therefore defrost the appliance 

regularly:

W

  Switch „Superfrost“ on one day before defrosting. The 

frozen goods are provided with a „cold reserve“.

W

  To defrost, disconnect the appliance from the mains or 

press the freezer on/off button so that the temperature dis-

play goes out. If the display does not go out, the child-proof 

lock is acti vated. 

W

  If possible, put the frozen goods in the freezer drawer with 

the cold-storage accumulators on top, wrap in newspaper 

or a blanket and store in a cool place.

W

  To speed up the defrosting process put a saucepan of hot 

but not boiling water on one of the shelves.

  Do not use electric heaters or steam clean ers, de-

frosting sprays or naked flames for defrosting nor any 

metal objects for removing the ice. Risk of injury and 

damage!

W

  Leave the door of the appliance open while defrosting. 

Soak up the defrost water in the recess in the floor with a 

sponge or cloth. Then clean the appliance and wipe dry.