Liebherr CBesf 4006 BioFresh - Инструкция по эксплуатации - Страница 4

14

Control elements 

You are advised to clean the appliance before switching it on 

for the first time (see "Cleaning").

Switch on the appliance approx. 2 hours before loading it with 

frozen food for the first time. Do not load with frozen food until 

the temperature shows at least -18°C.

Switching the appliance on and off 

Pressing the main on/off switch 

3

 always switches the

entire appliance, both the refrigerator and the freezer 

compartment, on or off.

W

Switching on

: Press the on/off buttons 

3

 or 

9

 so that the 

temperature displays light up or flash. 

- 

Refrigerator with BioFresh compartment

: The interior 

light will light up when the door is open.

- 

Freezer compartment

: When putting the appliance into 

operation and when it is warm, 

lines

 are shown in the 

freezer compartment display until a temperature less than 0 

°C is reached.

W

Switching off

: Press the main on/off switch 

3

 for about 

one second, so that the temperature displays go out.

W

  If you only want to 

switch off the refrigerator and Bio-

Fresh compartment

 (keeping the freezer compartment 

switched on; useful when you go on holiday, for example), 

press the 

on/off switch

9

. The 

refrigerator

 temperature 

display 

7

 and the interior light will go out. The 

freezer

temperature display 

1

 must remain on.

Setting the temperature 

The appliance is set as standard for normal operation mode,  

a temperature of + 5 °C is recomended for the refrigerator 

compartment and -18 °C  for the freezer compartment.

Lower temperature/colder: 

Press the

 Down-

setting but-

ton, left for refrigerator compartment: 

8

, right for freezer 

compartment: 

2

.

Increase temperature/warmer: 

Press the 

Up

-setting but-

ton. 

-  While you are entering the temperature, the 

set tempera-

ture will flash

 on the display. 

-  When you press the temperature setting buttons for the first 

time, the 

most recent setting

 (known as the

 "reference 

setting"

) is displayed.

-  You can change the settings in increments of 1°C by briefly 

pressing the buttons again.  If the buttons are held down 

the temperature setting will change faster.

-  Approximately 5 seconds after the button has been re-

leased, the display will automatically show the 

actual

 freez-

ing or cooling temperature (known as the "

actual setting

"). 

You can change the temperatures 

W

in the refrigerator: 

between 9 °C and 4 °C, and 

W

  in the freezer:

between -16 °C and -26 °C. 

  Whether you can obtain the lowest temperature depends 

on where the appliance is positioned (if it is located in an 

area with a high ambient temperature it will not reach the 

lowest temperature). 

W

  The temperature in the 

BioFresh compartment 

is con-

trolled automatically, between 0 and 3°C. If you require a 

higher or lower temperature, e.g. for storing fish, you can 

alter the temperature setting in the BioFresh compartment. 

For more information on this, please see the section "Ad-

ditional functions".

Temperature display 

In normal operation, the following settings will be displayed:

-  the 

average refrigerator temperature

 in display 

7

 and

-  the 

warmest frozen food temperature

 in display 

1

.

The display will flash:

-   if you change the temperature or

-   if the temperature rises by several degrees, indicating 

cold loss, e.g. if you place fresh, "warm" food in the freezer 

or if you remove or re-pack frozen food the temperature 

may rise for a short time due to warm air flowing into the 

freezer. Once you have finished loading or re-pack ing, the 

electronics will automatically re-set the temperature to the 

most recent setting. Short-term rises in temperature will not 

affect the frozen food.

W

  If "F 1" to "F 5" appears in the display, the appliance has a 

fault. Consult the customer service department indicating 

the fault number displayed.

Audible warning signal

The audible warning signal helps to protect frozen food and to 

save energy.

W

  The audible warning device is switched off 

by pressing 

the audible warning on/off button 

5

.

-  It switches off automatically as soon as the temperature is 

low enough. 

It always sounds 

-  if the freezer temperature is not low enough (dependent 

on the temperature setting). 

The temperature display 

flashes

 at the same time. 

-  if warm, fresh food has been placed in the freezer. 

-  if too much warm air from the outside has entered when 

re-arranging or removing frozen food.

The temperature display will continue to 

flash

 until the cause 

of the alarm has been rectified.

SuperCooling 

The SuperCooling button switches the refrigerator compart-

ment to maximum cooling. 

It is recommended particularly if you wish to cool 

large

 quanti-

ties of food, drinks, freshly baked cakes or meals rapidly.

W

Switch on:

 Briefly press SuperCooling button 

bl

so that it 

is lit.

  The refrigerator temperature will drop to its lowest value.

NB:

 "SuperCooling" consumes slightly more energy. After 

approx. 6 hours, however, the refrigerator switches back 

automatically

 to normal energy-saving operation.

  If required, the "SuperCooling" function can be switched off 

earlier.

W

Switch off:

 press again briefly, so that the button is unlit.