Liebherr CBesf 4006 BioFresh - Инструкция по эксплуатации - Страница 3

13

Safety instructions and warnings

W

 To prevent injury or damage to the unit, the appliance 

should only be transported wrapped and set up by two 

people. 

W 

 The refrigerant R 600a is environmentally friendly but flam-

mable.

W 

Do not damage the refrigerant circuit pipes. Splashes of refrig-

erant can harm your eyes or ignite. 

W

  If refrigerant escapes, remove all naked flames or sources 

of ignition in the vicinity of the leak, disconnect the appli-

ance from the mains and ventilate the area well.

W

  In the event that the appliance is damaged, contact the 

supplier immediately before connecting to the mains.

W

  To guarantee safe operation, ensure that the appliance is 

set up and connected as described in these operating in-

structions.

W

  In the event of a fault, disconnect appliance from mains: 

pull out the plug (do not pull on connection cable) or trip or 

turn out fuse.

W

  Any repairs and work on the appliance should only be 

carried out by the customer service department, as 

unauthorised work could prove highly dangerous for 

the user.  

The same applies to changing the mains power 

cable.

W 

Do not store any explosive materials or spray cans with 

flammable propellants in the appliance, such as butane, 

propane, pentane etc. Electrical components might cause 

leaking gas to ignite. You can identify such sprays by the 

printed contents or a flame symbol.

W

  Only store high-percentage alcohol in tightly sealed, up-

right containers.

W

  Do not allow naked flames or ignition sources to enter the 

appliance.

W

  Do not use electrical appliances inside the appliance (e.g. 

steam cleaners, heaters). 

W

  Do not stand on the plinth, drawers or doors or use them to 

support anything else.

W

  This appliance is not intended for use by persons (including 

children) with reduced physical, sensory or mental capabili-

ties or lack of experience and knowledge unless they have 

been given initial supervision or instruction concerning use 

of the appliance by a person responsible for their safety. 

Children should be supervised to ensure that they do not 

play with the appliance.

W 

Avoid prolonged skin contact with cold surfaces or chilled/

frozen food. This could cause pain, numbness and frostbite. 

In the case of prolonged skin contact, protective measures 

should be taken, e.g. gloves should be worn.

W

  Do not eat ice-cream, particularly ice lollies or ice-cubes, 

immediately after taking them from the freezer compart-

ment as there is a risk of "burning" because of the very cold 

temperatures.

W

  Do not consume food which has been stored for too long, 

as it could cause food poisoning.

W

The appliance is designed for use in enclosed areas. Do not 

operate the appliance outdoors or in areas where it is expo-

sed to splash water or damp conditions.

Setting up

W 

When setting up/fitting ensure that the refrigerant circuit 

pipes are not damaged. 

W 

Standard EN 378 specifies that the room in which you 

install your appliance must have a volume of 1 m

3

 per 8 g 

of R 600a refrigerant used in the appliance, so as to avoid 

the formation of inflammable gas/air mixtures in the room 

where the appliance is located in the event of a leak in the 

refrigerant circuit. The quantity of refrigerant is given on the 

type plate in the interior of the appliance.

W

  Always position the appliance directly up against the wall.

W

  Avoid positioning in direct sunlight or next to an oven, ra-

diator or similar, in damp locations or near spraying water. 

W

  Once in position, use the 10 spanner provided to adjust the 

feet so that the appliance is level and does not wobble. 

W 

The ventilation grilles should not be obstructed. Always 

ensure that there is good ventilation and that the out-

ward flowing air is able to escape. 

Condensation may form on the outside of the refrigerator/

freezer during periods of high humidity.Constant ventilation 

of the installation site is recommend.

  More information can be found in the installation and modifica-

tion instructions.

W

  Do not place heat-emitting appliances, e.g. microwave 

oven, toaster, etc., on top of the refrigerator or freezer. 

W 

In order to avoid the risk of fire, do not place any burning 

candles, lamps or other objects with open flames on the 

refrigerator/freezer.

W

  Remove all transportation safety components:

-  Remove sticky tape or spacers* from shelves and insert 

shelves in the required position.

-  Remove all protective film: from the decorative trims, front 

walls and side walls*. 

Connecting to the mains

Power supply (AC) and voltage

at the operating point must comply with the details on the type 

plate, which is located inside the appliance on the left, fig. 

A

.

W

Connect the appliance with a properly earthed  fused 

plug and socket only.

W

  The socket must be fused with a 10 A fuse or higher, it 

must be away from the rear of the appliance and must be 

easily accessible. 

W

  Do 

not

 connect the appliance to the supply with other 

equipment using an extension cable - risk of overheating.

W

  When removing the mains cable from the back of the ap-

pliance, remove the 

cable holder

 so as to avoid vibration 

noise.

Saving energy

-  Always ensure good ventilation. Do not cover ventilation open-

ings or grille.

-  Always keep fan louvres clear.

-  Do  not  place  appliance  in  areas  of  direct  sunlight  or  next  to  a 

stove, heater or similar object.

-  The energy consumption depends on the installation conditions, 

e.g. the ambient temperature.

-  Keep the time the appliance is open to a minimum.

-  Store food logically.

-  Ensure that all food is well packed and covered for storage. This 

will prevent frost from forming.

-  First cool warm food to room temperature before storing it.

-  Defrost frozen food in the refrigerator.

-  If there is a thick layer of frost in the appliance: defrost the appli-

ance.

-  Empty and switch off refrigerating unit for longer vacation periods.
Accumulated dust increases the energy consumption:

-  Once a year, dust the refrigerating unit together with the metal 

grille of the heat exchanger at the back of the appliance.