Ryobi RLM4614 5133002550 - Инструкция по эксплуатации - Страница 7

English

5

EN

FR

DE

ES

IT

NL

PT

DA

SV

FI

NO

RU

PL

CS

HU

RO

LV

LT

ET

HR

SL

SK

BG

UK

 WARNING

Never operate the product without the proper safety 
devices in place and working. Never operate the product 
with damaged safety devices. Operation of the product 
with damaged or missing parts could result in serious 
personal injury.

INSTALLATION

See figure 2.

■

Place handles in correct operating position and tighten 
handle knobs to secure.

■

Loosen rope guide knob, place starter rope in guide on 
handle, then retighten knob to secure.

■

Install grass catcher.

OPERATION

FUEL AND REFUELLING

 WARNING

Always handle petrol with care; it is highly 

fl

 ammable.

■

Use fresh fuel.

■

Store fuel in containers specifically designed for this 
purpose.

■

Always refuel outdoors where there are no sparks and 
flames. Do not inhale fuel vapour. Do not smoke and 
stay away from open 

fl

 ames and sparks when 

fi

 lling fuel 

tank or when handling fuel.

■

Do not let petrol or oil come in contact with your skin.

■

Keep petrol and oil away from the eyes. If petrol or oil 
comes in contact with the eyes, wash them immediately 
with clean water. If irritation is still present, see a doctor 
immediately.

■

Clean up spilled petrol immediately.

FILLING THE TANK

See figure 3.

 WARNING

Always shut off engine and allow it to cool for 5 minutes  
before refuelling. Never remove the cap of the fuel tank 
or add petrol to a machine with a running or hot engine. 
Move at least 9 m (30 ft) from refuelling site before 
starting the engine. Do not smoke. Failure to heed this 
warning could result in serious personal injury. 

 WARNING

Do not over

fi

 ll. Fill the fuel tank to 25 mm below the top 

of the fuel neck. After fueling, never tilt the mower more 
than 25 degrees for this could result in fuel leakage and 
risk of 

fi

 re, etc.

■

Clean surface around fuel cap to prevent contamination.

■

Loosen fuel cap slowly to release pressure and to keep 
fuel from escaping around the cap. Rest the cap on a 
clean surface.

■

Carefully pour petrol into the tank. Avoid spillage.

■

Clean and inspect the gasket, then replace all fuel and 
container caps securely. 

■

Wipe up any fuel spillage. Move 9 m away from 
refuelling site before starting engine.

NOTE:

 It is normal for smoke to be emitted from a new 

engine during and after 

fi

 rst use.

ADDING/CHECKING ENGINE OIL

See figure 3.

Engine oil has a major in

fl

 uence on engine performance 

and service life. For general, all-temperature use, SAE 
10W-30 is recommended. Always use a 4-cycle motor oil 
that meets or exceeds the requirements for API service 
classi

fi

 cation SJ.

NOTE: 

Non-detergent or 2-cycle engine oils will damage 

the engine and should not be used.

To add engine oil:

■

Be sure mower is level and area around oil cap/dipstick 
is clean.

■

Remove the cap and seal from oil bottle.

■

Unscrew the oil cap/dipstick and remove.

■

Slowly add oil. Fill to the “Full” line on dipstick. Do not 
overfill.

NOTE: 

When checking the oil level, seat the dipstick in 

the oil fill hole but do not screw in.

■

Reinstall the oil cap/dipstick and secure.

To check engine oil:

■

Be sure mower is level and area around oil cap/dipstick 
is clean.

■

Remove the oil cap/dipstick. Wipe clean and reseat in 
oil 

fi

 ll hole but do not screw in.

■

Remove the oil cap/dipstick again and check oil level. 
Add oil as needed.

STARTING/STOPPING THE MOWER

See figure 3.