Korting OKB 9113 CFX - Инструкция по эксплуатации - Страница 25

TECHNICAL CHARACRETISTICS 

 
Voltage and power supply frequency:  220-240 V ~ 50/60 Hz 
 
Oven capacity, Lt: 

65 

For the detailed information about the technical characteristics of the oven, see the 

technical data label

 on 

the back of the last page of the present manual, or the 

product

data plate, 

that is located in the outer part of 

the oven cavity and is visible when the door is open.

 
INSTALLATION 
 

Remove the appliance from the package and check that the product and power cord are NOT damaged. 
Otherwise, contact the retailer before operating the appliance. 
Do not lift the product by the door handle. 
Packaging (e.g. paper, polystyrene) may be hazardous for children (danger of suffocation). Keep packaging 
out of the reach of children. 
 
The product must be installed and connected correctly to the mains power supply, following the 
manufacturer's instructions and only by 

QUALIFIED PERSONNEL

. 

Before performing any type of work, always check out that the appliance is 

DISCONNECTED

 from the  

mains power supply. 
 
To guarantee proper operation of the built-in appliance, the kitchen furniture unit must have the following 
characteristics: 
 - the panels adjacent to the oven must be constructed in heat resistant materials; 
 - in case of veneered wood furniture units, the glue must be heat resistant to temperatures up to 100°C; 
 
The oven must be located in a standard opening of 560 mm, as shown in 

figure 1

 on the page 4 of the 

present instructions manual, whether under a counter or in column position. 
When inserting the oven into a column it is necessary to ensure adequate ventilation by installing openings 
as illustrated in the figure. 
The oven is secured to the furniture unit by the screws located in the holes of the frame. 
Make sure not to lift the oven by its door when inserting it; furthermore, do not place excessive pressure on 
the door when it is open. 
 

Note

: if no opening has been anticipated in the upper part of the column furniture, make a hole which is 

560mm wide and 40-50mmm high in the lower part of the column. 

The manufacturer is not responsible for any damage to persons or property, caused by 
improper installation, use or maintenance of the appliance. 
 
The manufacturer declines all responsibility if the safety standards are not observed. 
 
The manufacturer reserves the right to make any modifications to its products which result 
necessary or useful without any prior notice. 

23