Fulgor Milano FCO 9013 TM BK - Инструкция по эксплуатации - Страница 74

EN

34

4. Slide out the internal glass as shown below. Remove the 

second and third panes of glass (middle panes) for cleaning 

sliding out the rubber strip.

5. Replace the middle panes after cleaning in reverse order, 

checking that they are oriented so the words INTERNAL 

SIDE are properly legible.

NOTE:  a slight gap between the middle panes and the side 

supports is normal because it allows for the heat 

expansion of the glass.

6.  Place the pack of three glass panes between the two uprights 

and replace the top strip. 

Replacement of the oven light

WARNING

Make sure that: 
• The oven and lights are cool and power to the oven has 

been turned off before replacing the light bulb(s). Failure 

to do so could result in electrical shock or burns. 

• The lenses must be in place when using the oven. 
• The lenses serve to protect the light bulb from breaking. 
• The lenses are made of glass. Handle carefully to avoid 

breakage. Broken glass could cause an injury.

1

3

2

(230V - 25W  G9)

1

3

(230V - 15 or 25W)

2

2

(230V - 25W  G9)

1

1  Turn off power at the main power supply (fuse or breaker 

box). 

2  Remove the lens (1).

3  Remove the light bulb (2) from its socket (3).  

4  Replace the bulb (2) with a new one. Avoid touching the 

bulb with fingers, as oils from hands can damage the bulb 

when it becomes hot. 

5  Use one with the same Volt and Watt (see figure). 

6  Screw the lens (1) back on. 

7  Turn power back on at the main power supply (fuse or 

breaker box).