Redmond RK-M143-E - Инструкция по эксплуатации - Страница 6

6

W

ater boiling 

1.  Press the «0/I» button. A short audible signal will be heard, and the process of 

water heating will start. The button illumination will light up solid during the 

operation. 

2.  The appliance will be automatically turned off after boiling.   

3.  To interrupt the heating process lift the «0/I» button.

The settings are saved if the kettle is lifted off the base during operation. The 

appliance operation will be restarted automatically after returning the kettle 

to the base. 

Safety system 

•  The kettle is supplied with an automatic shut-off system upon boiling.
• 

In case of water shortage the automatic overheat protection will turn off 

the kettle. Wait till the appliance is cooled, thereafter it will be ready for 

operation. 

I I I.  C L E A N I N G A N D  M A I N T E N A N C E 

Unplug the kettle and allow it to cool before cleaning. 

DO NOT use solvents (petrol, acetone, etc.), abrasive cleansers, and abrasive 

coated sponges while cleaning. 
ATTENTION! Before repeated usage make sure that the electrical contacts are 

kept dry! 

Base and body cleaning 

Clean the kettle body and base with a soft cloth. Dry the kettle before operation. 

ATTENTION! Never immerse the kettle, the base, the power cord or the sock

-

et in water: the electrical contacts should not contact with water. 

Descaling 

During operation, depending on the composition of usable water, oxide spots and 

scale can appear on the heating element and inner walls of the appliance. To remove 

it  use  special  nonabrasive  cleansers  for  scale  cleaning  and  removal  from  kitchen 

appliances. 

1.  Pour water into the kettle ¾ from maximum capacity and bring to a boil.   

2.  After the kettle turns off, add eight percent acetic acid solution to the maximum 

level on the inner surface of the body. 

3. 

Leave this solution inside the kettle for several hours. 

4.  Empty the kettle and rinse properly.

5. 

Fill the kettle with clean water up to the maximum level on the inner surface 

of the body and bring it to boil. 

6.  Empty the kettle and rinse it again. If scale still remains, repeat the procedure 

mentioned above. 

You can also use special means for descaling. Follow manufacturer’s instructions in 

this case.  

Removable scale filter cleansing 

1. 

Open the lid. Remove the filter pulling it upward. 

2. 

Rinse the filter. You can use a dishwashing solution. 

3. 

Place the filter into the kettle with the projection to the centre.

IV. BEFORE CONTACTING SERVICE CENTRE 

Problem

Possible causes

Solution

The appliance 

does not turn 

on

Voltage supply failure 

Ensure the appliance is plugged into 

the working outlet. Check the pres-

ence of utility-supplied voltage

The kettle 

turns off 

untimely

The scale on the heating 

element appeared 

Clean the heating element from the 

scale (ref. to “Cleaning and mainte-

nance”)

The kettle 

turns off in 

several 

seconds 

Not enough water in the 

appliance,  overheating 

protection was activated 

Turn off the appliance and allow it 

to cool. For further operation fill the 

kettle  with  water  above  the  mini

-

mum  level  on  the  inner  surface  of 

the body