Falmec CIRCLE.TECH Levante 120 ISOLA - Инструкция по эксплуатации - Страница 14

14

CARBON-ZEO FILTERS

In normal use conditions, we recommend regenerating the zeolite-carbon filter every 18 months 
and replacing it after 3 years. Simply place it in a domestic oven at a temperature of 150°C for 
approximately 1 hour to regenerate it.
Wait until the filter cools before reassembling it. 

LIGHTING

The range hood is equipped with high efficiency, low consumption LED lighting with ex-
tremely long duration under normal use conditions.
In case of failure, contact the Dealer or an authorised Servicing Department for repairs.

TROUBLESHOOTING

Description

Possible cause

Solution

The hood motor is 
not working

The hood is not powered

Power the hood

The hood is positioned wi-
thin 3cm from the ceiling

Lower the hood

The motor is faulty

Contact the after-sales Service 
centre

The lighting is not 
working

The hood is not powered

Power the hood

The lamp power supply 
unit is faulty

Contact the after-sales Service 
centre

The lamp is faulty

Contact the after-sales Service 
centre

The hood does 
not move

The hood is not powered

Power the hood

Protection fuse triggered

Replace fuse 5x20 2A delayed

Moving system failure

Contact the after-sales Service 
centre

Suspension
ropes worn

Incorrect installation

Contact the after-sales Service 
centre

Ageing

Contact the after-sales Service 
centre

MOTOR EMERGENCY HANDLING
(ONLY FOR SERVICE PERSONNEL)

phase

Description

1

Arrange a 24V DC power supply unit,
70W minimum

2

Open the panel and remove the LH filter

3

Open the door removing the screws

4

Remove the fuse

5

Connect the power supply unit to the termi-
nal board

 DISPOSAL AFTER END OF USEFUL LIFE

The crossed-out trash or refuse bin symbol on the appliance means that 

the 

product is WEEE

, i.e. 

“

Waste electrical and electronic equipment'', accordingly 

it 

must not be disposed of with regular unsorted waste

 (i.e. with ''mixed house-

hold waste''), but it must be disposed of separately so that it can undergo specif-

ic processing for its re-use, or a specific treatment, to remove and safely dispose of any 
substances that may be harmful to the environment and remove the raw materials that can 
be recycled. Proper disposal of these products contributes to saving valuable resources and 
avoid potential negative effects on personal health and the environment, which may be 
caused by inappropriate disposal of waste.
You are kindly asked to contact your local authorities for further information regarding the 
designated waste collection points nearest to you. Penalties for improper disposal of such 
waste can be applied in compliance with national regulations.

INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES

The EU WEEE Directive was implemented differently in each country, accordingly, if you wish 
to dispose of this appliance we suggest contacting your local authorities or dealer to find 
out what the correct method of disposal is.

INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUNTRIES

The crossed-out trash or refuse bin symbol is only valid in the European Union: if you wish 
to dispose of this appliance in other countries, we suggest contacting your local authorities 
or dealer to find out what the correct method of disposal is.

WARNING!

The Manufacturer reserves the right to make changes to the equipment at any time and 
without prior notice. Printing, translation and reproduction, even partial, of this manual are 
bound by the Manufacturer's authorisation. 
Technical information, graphic representations and specifications in this manual are for in-
formation purposes and cannot be divulged.
This manual is written in Italian. The Manufacturer is not responsible for any transcription 
or translation errors.

Movement Terminal 

board 

Power supply 
unit

Hood 
coming 
down

Red
Black

+
-

Hood 
going up

Red
Black

-
+