Водонагреватели Clage DSX Touch 039534 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
CLAGE
27
EN
4. Remote control
5. The display switches to the setpoint value display.
Note: For initial installation we basically recommend to change the radio channel.
In the case of an unsuccessful registration the display indicates “
no
” by a flashing
radio signal after 45 seconds. The remote control quits the registration process and
switches to standby mode. By pressing a key the registration process will be repeated.
Notes:
• With no remote control registered or without working radio connection, the instan-
taneous water heater heats to the prior selected set temperature.
• For the professional: After a reset at the water heater (refer to installing instructions,
chapter “Reinstallation”) a registration is required!
Handling
The remote control is equipped with the following functions:
1. Arrow buttons
You can set the required temperature gradually to a lower or higher value using the
arrow two buttons and .
Note: If the temperature display is set to “
--
” with arrow button , the instanta-
neous water heater switches off the heating function.
2. Programme buttons
The two programme buttons and allow to quickly select the preset temperature
without the need to press the and buttons several times.
The factory setting for programme is 35 °C and for programme it is 48 °C. You can
assign your own settings for the programme buttons:
• Select the desired temperature with and .
• To save the current temperature, press the programme button
or
for about two
seconds.
Displayed information
Energy saving mode
The symbol
shows that the appliance works in an energy saving mode, i.e. the
momentary energy consumption is subject to the selected temperature and to the flow
rate in the energy saving mode.
Power limit
If the full output of the instantaneous water heater does not suffice to heat the tapped
quantity of water, this will be indicated by
on the LCD.
Operation with preheated water
If the cold water inlet temperature is higher than the set value of the hot water outlet,
the instantaneous water heater will not heat. In this case no power is emitted and the
sun symbol is displayed.
