Fulgor Milano CPH 402 G TC X - Инструкция по эксплуатации - Страница 23

22

23

GB

Mod. 2G

Adaptation to varius types of gas (Fig. 10)

Should the appliance be pre-set for a different type of 
gas than available, procreed as follows:
•  replace the injector (Fig. 7) with the corresponding  type 

of gas to be used (see table “User characteristics“);

A

B

Mod. Dual

Fig. 10

Minimum burner capacity regulation procedure

The procedure for acquiring the minimum capacities 
allows the operator to change the minimum capacity 
programmed, adapting every burner to the characteristics 
of the gas distribution network to which the hob is 
connected. 
The procedure is activated by pressing the +A and –A 
keys together with the +B key constantly for 3 seconds, 
with the burners all switched off. 
The activation of the regulation procedure is indicated 
on the display with the word "MIN". It is now possible to 
select the burner to regulate using the respective + and – 
keys. After pressing one of the keys, the burner selected 
will come on at minimum level and it will be possible to 
increase or reduce the capacity to the minimum level 
using the using the + and – keys for this burner. During 
the display regulation procedure, the flame display levels 

will show the indication - if the minimum level programmed 
corresponds with the factory setting, and the indication will 
change ^ or v in flashing mode, indicating a higher or lower 
capacity than that programmed. The procedure ends by 
pressing the PT key. The minimum capacity levels will 
then be acquired and memorised by the device, and will 
be used in the normal use of the hob.

Selecting the type of fuel gas

You can configure the cook top to work with different 
gases (see table 1). To select the fuel gas to use, the 
cook top must be on with all the burners off. Just press 
the burner A, burner B and B- keys together for at least 2 
seconds. When the fuel gas selection procedure starts, 
the burner level display turns off and the timer display 
shows “2020”, “3029”, “2525” or “2010”, depending on 
the current configuration in use. It is possible to select 
the desired setting with the A+ and A- keys. To end the 
procedure, you must press the PT key.
Using this function deletes any turn-off times that may 
have been programmed for the burners.

Electronic self-test

The electronic cards are continuously checking their 
status. If there are any hardware or board problems that 
could affect the end-user's safety, the cook top goes 
into a “safe” mode which closes the solenoid valves and 
displays a code relative to failure.