Fulgor Milano CPH 402 G TC X - Инструкция по эксплуатации - Страница 17

16

17

GB

it is necessary to press the PT and KL keys at the same 
time, for at least 3 seconds.
The flashing digit to the left of the dot indicates the hours, 
while those to the right indicate the minutes. It is possible 
to increase or decrease the hours using keys +A or -A 
and by keeping keys +A or -A pressed the change in the 
number of hours takes place continuously. 
To regulate the minutes, press the PT key again. The 
digits to the right of the dot will start flashing. Now change 
the minutes in the same way as indicated for the hours. 
Press the PT key to memorise the time programmed.

Releasing the burner

When a burner is locked the relative display shows the 
letter "B". The burner is released by pressing the –A 
and KL keys together constantly for at least 2 seconds. 
When released, the burners are reset to level 0, ready 
to be lit again.  
N.B: If the release procedure is repeated 5 times in a row 
during a 15 minute time span, the device will indicate 
Ft06 and will accept no further request for release for 
another 15 minutes. 

Locking the control panel

This is activated by pressing the KL key for at least 2 
seconds. All burner levels will remain stable. The control 
panel locked status occurs when the decimal points on 
the display of the capacity level related to each burner 
light up. While the control panel is locked it is no longer 
possible to change the levels of the burners or change 
the timer settings, but it is possible to switch off the hob 
by pressing the ON/OFF button.
It is not possible to release a locked burner when the 
control panel lock is active. It will be therefore necessary 
to release the control panel before activating the burner 
release procedure.

Releasing the control panel

The control panel is released by pressing the KL and +A 
keys for at least 2 seconds. The control panel is released 
when the flame level points on the display go out.

Residual Heat

When a burner goes out, the relative display shows an 
"H" to indicate that the temperature of that burner is still 
high and the relative LED near the timer display remains 
on.
The "H" symbol and the LED turn off when the 
temperature of the relative burner is cool.

Special slow cooking (Duty cycle)

This function turns any cook top burner on and off is the 
sequence shown in the table.

LEVEL SET.

1

2

3

4

5

TURN-OFF TIME

10 

Sec.

20 

Sec.

30 

Sec.

40 

Sec.

50 

Sec.

TURN-ON TIME

50 

Sec.

40 

Sec.

30 

Sec.

20 

Sec.

10 

Sec.

The function is activated by pressing the + key of the 
burner you want to apply it to, and the PT key (the burner 
involved must be off when this function is activated).
The burner turns on at level 3 and, at that time, you can 
set the level to apply the function to by pressing the + 
and - keys.
If, for example, you set the value to level 1, the burner 
will remain on for 50 seconds, then it will turn off for 10 
seconds and repeat this cycle until you turn the burner 
off.
If the user does not intervene, the hob switches off 
automatically after 60 minutes. When this function is 
active, the display of the burner on which it is active 
flashes.